Figure 1.7.3.1: Ramp Shape - GE AV-300i User Manual

Ramp input=0
Ramp output=0
Ramp freeze
Ramp setpoint
Ramp function
RAMP CONFIG Ramp funct src
Ramp input=0
Ramp output=0
Ramp freeze
Ramp funct cfg
Ramp out enable
Ramp shape
Ramp funct mon
Ramp out mon
Ramp acc state
Ramp dec state
Ramp out != 0
Ramp cmds mon
N !
OTE the acceleration/deceleration state makes reference to a speed increase/decrease with an
absolute value.
AV-300i Version 2 User's Guide
Ramp shape
Selection of the source Ramp imput=0
Selection of the source Ramp output=0
Selection of the source Ramp freeze=0
Ramp enabling
Ramp selection. Linear or S-shaped ramp
Ramp output monitor
Ramp state. 1 = Acceleration
Ramp state. 1 = Deceleration
Ramp output different from zero. If enable = 0. If disable = 1
Command monitor for the ramp Block
Bit 0 -> Ramp output = 0, if ONE the value is 1
Bit 1 -> Ramp input = 0, if ONE the value is 2
Bit 2 -> Ramp freeze, if ONE the value is 4
Bit 3 -> Ramp out enable
n

Figure 1.7.3.1: Ramp Shape

—————— Function Description ——————
Ramp out mon
Ramp out enable
Ramp shape
t
Ch.1
89