Electrolux 6 GN 1/1 User Manual page 27

Anom- Type of
Description
aly anomaly
ACF Warning Air filter absent
ACUM Stops oven Main electronic board
not identified
ASCH Warning Component compart-
ment temperature
warning
BEtc Stops Error, excessive time
cleaning on closing operation
during cleaning
BEto Stops Error, excessive time
cleaning on opening operation
during cleaning
BEtr Warning Boiler excessive tem-
perature raising time
Bhtc Warning Warning on excessive
time on closing
operation
Bhto Warning Warning on excessive
time on opening
operation
bntC Stops Boiler SSR NTC failure
boiler (NTC4)
BoLt Stops Boiler water loading
cycle (if the timeout
cycle
needs the
boiler)
BSHt Warning Boiler SSR NTC
(NTC4) high
temperature
Possible causes
• Filter not detected;
• Possible damage to inter-
nal electric and electronic
components due to air
filter absence.
Communication problem
with the main electronic
board.
• Filter is dirty;
• Too high room
temperature.
Mechanical or electrical
problem with vent valve.
Mechanical or electrical
problem with vent valve.
The oven has detected a
low performance in the
boiler.
• Flap (venting valve)
motoreducer or micro
switch failure.
• Obstruction at the vent-
ing valve inlet.
• Flap (venting valve)
motoreducer or micro
switch failure.
• Obstruction at the vent-
ing valve inlet.
Temperature sensor issue.
• Water supply (pressure/
quality of water).
• Electric insulation prob-
lem with water level
sensors.
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
Actions
• Refit the filter;
• If the problem persists call Service.
• Switch the oven OFF/ON;
• If the error persists, call Service.
• Check room temperature considering the
oven needs fresh air to cool electronic
compartment.
• Clean the filter;
• Allow oven to cool before cooking;
• If the problem persists, call Service.
Call Service
Call Service
• It is possible to cook. Verify the cooking
results.
• If the warning persists call Service.
It is possible to continue using the oven. Cooking
results maybe different from usual.
• With the oven OFF and cold, check if any
obstruction at the ventilation chimney on the
top of the oven: remove the obstruction if any;
• If the problem persists, call Service.
It is possible to continue using the oven. Cooking
results maybe different from usual.
• With the oven OFF and cold, check if any
obstruction at the ventilation chimney on the
top of the oven: remove the obstruction if any;
• If the problem persists, call Service.
The oven has detected a problem with boiler
operation.
• Verify cooking results;
• If the problem persists, call Service.
• Check if the water supply is open;
• Check if the water pressure is not too low;
• Verify if the water filter is clogged. Clean it or
replace it;
• Mechanical problem with boiler operation. If
the problem persists call Service.
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform Service);
• If the error persists, call Service.
27