Programs - Electrolux 6 GN 1/1 User Manual

2. Keep pressed the multiphase button
3. Set phase 2
• It is possible, at this stage, to set the parameters of the
new phase.
• Repeat the sequence for all phases to be set.
4. At the end press START button
To delete a phase:
1. Select the phase to be deleted using the arrows < / > on the
keypad
2. Keep pressed the waste bin icon.
NOTE!
By deleting an intermediate phase, the following
phases will also be automatically cancelled.
UTILITIES
Utilities are functions that can be added to the cooking cycle.
They are activated simply by pressing the relative button.
Pause
• Add a new phase;
• Press the Pause button
• Set the desired duration using the TIME button.
NOTE!
This utility can be used as delay start if set at the
beginning of a multiphase cycle.
Hold
• Pressing the Hold button
end of the cooking cycle.
During the holding phase the letter H appears in the Multi-
phase Display while the Time display shows HOLd.
• If cooking is time driven, the holding temperature is + 65 ℃. If
cooking is probe driven the holding temperature is 5 ℃ more
than the set core temperature.
Boiler Drain
• The boiler can not be drained during a cycle.
Cool Down
• The cool down can not be activated during a cycle.
• The default temperature is 25 ℃, but can be changed by
setting it on the keypad.
• To see the actual temperature of the cell, keep the Temper-
ature button pressed for more than 2 seconds.
F.5

Programs

The Programs button allows to recall cooking cycles already
stored or create and store new ones.
To exit from the Programs keep pressed one of the cooking
modes.
A
B
Program saving
C
• Set first a cooking cycle (refer to F.4 Cooking cycle setting
paragraph);
D
to add phase 2;
to start the cooking cycle.
;
will add the holding phase at the
• Keep pressed the Programs button. The display shows the
first program number available;
• Select the desired Program number (01–99) using the arrows
< / >;
• The Programs Display will continue to flash for a few seconds;
to complete the procedure keep pressed again the same
button for a few second until beep confirms the program
saving;
• Press now the Start button
Program deleting
• Select the program to be deleted;
• Keep pressed the <
press the same button again to confirm deleting procedure.
Uploading / downloading Programs
This procedure is only possible from the starting oven status.
NOTE!
To reach the oven starting status keep pressed one
of the available cooking modes as shown in the
figure.
1. Insert the USB pendrive into the socket.
2. To upload / download Programs, keep pressed the Programs
button until the PrOG appears on the Temperature display.
3. Use the arrows buttons < / > on the keypad to select
"upload" or "download " command.
The word "dnLo" or "UPLO" appears on the Time display
according your selection.
4. Keep pressed the Programs button to start the uploading or
downloading procedure.
All the control panel indicators light flash.
5. At the end, on the Time Display the flashing word End
appears to confirm the completed operation.
G
6. Remove the USB pendrive from the socket.
H
Downloading HACCP log
This procedure is only possible from the starting oven status.
1. Insert the USB pendrive into the socket.
I
2. To download the HACCP log, keep pressed the HACCP
button until the word HACP appears on the Temperature
display.
The word "dnLo" appears on the Time display.
3. All the control panel indicators light flash.
to start the program.
(delete) button for a few seconds and
19