Operating the service processor
FUNCTION =>
SELECTION=>
LD PROGRAM LOAD
ST STATUS DISPLAY
MA MANUAL OPERATION
AD ALTER/DISPLAY
ME MESSAGE
CH CH/SUBCH STATUS
AU AUXILIARY
MF MSF
PA PERORMANCE ANALYZER Performance analysis
EXECUTION
V
1
2
3
4
5
6
7
U41859-J-Z126-2-76
The desired function can be selected by entry of a number listed in
the EXECUTION column or a letter combination listed in the
SELECTION column.
After entering the appropriate letter combination you can switch to
the following SVP FRAMEs:
The following function is executed after the corresponding number
has been entered:
CAUTION!
The functions are executed according to the entries in the CPU SELECT and
STOP/START MODE fields (see table on next page)!
CPU STOP
INTERRUPT
TOD ENABLE
SYSTEM RESET
SYSTEM RESET CLEAR
STORE STATUS
RESTART
Load BS2000
Display status
Manual operations
Alter/display storage/register
Display message
Display status of channel/subchannel
Auxiliary controls
Display FLAG codes
stops either the CPU selected in the CPU SELECT
and STOP/START MODE fields or all CPUs
creates an external interrupt for the CPU selected
in the fields CPU SELECT and STOP/START
MODE
time entry is enabled
all CPUs, channel processors, channels and
controllers are reset
as 4; in addition, the working memory is erased
selected CPU is stopped, the status is stored
starts the system again (this function is only
possible if the operating system has a restart
facility)
SVP frames and subframes
page 27
page 34
page 35
page 37
page 41
page 42
page 44
page 53
page 54
25