Drive Pc2303-012-N Status Led Code List; Running Belt High Speed Application; System Flash Log Retrieval - GE T2100-ST1 Service Manual

Troubleshooting

Drive PC2303-012-N status LED CODE list

When the drive is faulted, the Status LED blinks out the fault code.
The Status LED blinks the proper number of times, pauses with the
Status LED off, and then repeats the blink code.
Status Code
No Blink
Fast Blink
LED Off
1 Blink
2 Blink
3 Blink
4 Blink
5 Blink
6 Blink
7 Blink
8 Blink
Note 1: Contact local GE customer support representative for possible Drive

Running Belt High Speed Application

When operation the treadmill at a High-Speed Application. The
running belt is displaying hesitation/slippage of the running belt
with each foot plant. The following may be detected:
NOTE:
The running deck is reversible providing a new running
surface. If both sides of the running deck have been used
replace running deck.

System Flash Log Retrieval

When retrieving on UPS (Software Version 1.1812 and later
FGLF0495-03 Smart Power Supply system flash log file power the
98
Description
No faults, power stage enabled
No faults, power stage disabled
Ac line power insufficient
PWM_CMD Stuck Low
Gcoder Feedback Error
Not Used
Output Over Current
Control Supply Under Voltage
Drive Over Temperature
Bus Over Voltage
Output Short Circuit
PC2303-012-N replacement.
• Inspect the backing of the running belt for a fabric
breakdown, replace the running belt and flip running
deck.
• If grooves are found on the running deck. Inspect the
running belt fabric. If running belt backing exhibits
abnormal wear replace running and flip running deck.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Fault Retention
-
-
-
Latched (See Note 1)
Latched (See Note 1)
-
Latched (See Note 1)
Self-Resetting
Latched (See Note 1)
Self-Resetting
Latched (See Note 1)
2097937-002 Rev G
11 March 2019