Conversion Index; Change During Operation; 2-Set-Up; Type - GE AF-60 LP Programming Manual

5.2.1. Conversion Index

The various attributes of each parameter are displayed in the section Factory Settings. Parameter values are transferred as whole numbers only. Conversion
factors are therefore used to transfer decimals according to the table below.
Example:
Par. 1-24 Motor Current has a conversion index of -2 (i.e. conversion factor of 0.01 according to the table below). To set the parameter to 2.25 A, transfer the value
225 via Modbus. The Conversion Factor of 0.01 means that the value transferred is multiplied by 0.01 in the drive. The vale 225 transferred on the bus is thus
perceived as 2.25 A in the drive.
Conversion index
2
1
0
-1
-2
-3
-4
-5
Table 5.1: Conversion table

5.2.2. Change during operation

"TRUE" means that the parameter can be changed while the frequency converter is in operation and "FALSE" means that the frequency converter must be stopped
before a change can be made.

5.2.3. 2-Set-up

"All set-up": The parameter can be set individually in each of the two set-ups, i.e. one single parameter can have two different data values.
"1 set-up": Data value will be the same in both set-ups.

5.2.4. Type

Data Type
2
3
4
5
6
7
9
Conversion factor
10
100
1
0.1
0.01
0.001
0.0001
0.00001
Description
Integer 8
Integer 16
Integer 32
Unsigned 8
Unsigned 16
Unsigned 32
Visible string
AF-60 LP™ Micro Drive Programming Guide
Type
Int8
Int16
Int32
Uint8
Uint16
Uint32
VisibleString
5
67