Workpiece Spacing: Int - Panasonic LP-GS Series Serial Communication Command Manual

3-11-4 Workpiece spacing: INT

Supported model: LP-RC series / LP-RF series / LP-RV series
Sets the distance between the workpieces for the on-the-fly marking at regular intervals for the selected marking file.
⿎ Setting request data / response data for readout
Start
INT
code
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
INT
code
⿎ Data description
Name
Workpiece spacing
Total data length
⿎ Example of command settings
Condition: Workpiece spacing = 200
• Setting
Transmission data
• Readout
Transmission data
Response data
126
Sub [Workpiece spacing]
command 6-byte
R (Check sum)
Data length
Data contents
[byte]
6 "0000.0"–"4000.0" [mm]
6 Fixed length.
[STX]
[STX]
[STX]
(Check
sum)
End code
Only when trigger mode is set to "Marking
at regular intervals", set this value.
INT S 0200.0 [CR]
INT R [CR]
INT A 0200.0 [CR]
ME-LP-GS-SR-COMP-3
End code
Remarks