Panasonic LP-GS Series Serial Communication Command Manual page 121

⿎ Setting request data / response data for readout: when mark OFF setting
Start
SRA
code command
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Data description
Data length
Name
[byte]
Adjustment No.
Adjustment object
Target row
Target column
Target row
Target column
Min. 9
Total data length
Max. 603
⿎ Example of command settings
Condition: Adjustment No. = 01, Adjustment object = 2,
Target row = 4, Target column = 4, Target row = 8, Target column = 8
• Setting
Transmission data
• Readout
Transmission data
Response data
• With LP-400/V compatible command mode, the Mark OFF can not be set to the unit of whole rows and columns.
• With LP-400/V compatible command mode, the setting cannot be readout if the Mark OFF is set to other than the single
step.
[Adjustment No.] [Adjustment object]
[Target row] [Target column]
Sub
( [Target row] [Target column] ...)
At setting: 3 + 6n-byte
At readout: 9-byte
Data contents
2 "00"–"99"
1 "2": Mark OFF
3
3
"001"–"400"
(3)
(3)
Variable length with 3 + 6n-byte
n = number of the setting pairs of row and column (n ≦ 100)
• When setting only one pair of row and column: 9-byte
• When setting 100 pairs of row and column: Max. 603-byte
• Response data for readout: 9-byte
[STX] SRA
[STX] SRA
[STX] SRA
ME-LP-GS-SR-COMP-3
If the several pairs of the target row and target
column are specified, each setting is set in the
subsequent No. from the specified No.
• When the mark OFF setting is applied to only
one data, do not send the further data.
• Specify both row and column. It is not possible
to omit one side of them.
• When the mark OFF is set to two or more data,
set the next row and column in series. These
settings are set in the subsequent adjustment
No.
• Max. 100 pairs of row and column can be set.
S 012004004008008
R 01 [CR]
A 012004004 [CR]
(Check
End code
sum)
Remarks
[CR]
121