Connecting A Remote Camera - Panasonic AK-HRP200G Operating Instructions Manual

System connection diagram
„ IP connections
„
External DC
power supply
1.
Connect the IP connector <LAN> of the unit and LAN
connector on the back of the CCU with a LAN cable
(option).
• When connecting via a switching hub (100base-TX), use a straight
cable (category 5 or better shielded cable) for the LAN cable. When
not connecting via a switching hub, use a cross cable (category 5 or
better shielded cable) for the LAN cable.

Connecting a remote camera

„ Serial connection (AW-HE870)
„
I/F remote connector
External DC
power supply
12V IN LAN RS-422 PREVIEW
CCU
SIGNAL GND
AK-HRP200
36
(continued)
AK-HCU200
AK-HCU200
Switching hub
(100base-TX)
LAN cable (straight cable)
Max. 100 m
12V IN LAN RS-422 PREVIEW
CCU
SIGNAL GND
AK-HRP200
AW-HE870
DC cable supplied
with AW-HE870
AW-CA50T8
(10 m)
AC adapter
AW-PS510A
Personal computer
LAN cable (straight cable)
2.
When you have finished connecting the equipment,
turn on the main power of the CCU and then turn on the
external DC power supply of the unit and the power of
the camera.
<Note>
• If a camera is not connected, some of the control functions from the
unit to the CCU will be limited.
• Up to 19 CCUs (AK-HCU200) can be controlled from the unit.
• To use a CCU via an IP connection, you need to configure the
settings with ROP Setup Software (accessory). Before using ROP
Setup Software, connect the unit to the personal computer with a
LAN cable.
• For details on the settings for IP connections, refer to Operations
and Settings on the supplied CD-ROM.
1.
Connect the RS-422 connector <RS-422> of the unit and
the I/F REMOTE connector of AW-HE870 with an optional
AW-CA50T8 connection cable.
2.
When you have finished connecting the equipment, turn
on the power of the camera and the power of the unit.