Configuration Switches - GE D485 Instruction Manual

INSTALLATION
CONFIGURATION
SWITCHES
2–6
Table 2–5: D485 status indicators
Number Description
1 Network status
2 Module status
3 Not used
4 Not used
5 Modbus
status *
6 Device status
* This LED turns green when all transactions have been active at least once. This includes any
transactions using "change of state" or "change of state on trigger". If a timeout occurs on a
transaction, this LED will turn red.
The configuration switches are used to set the DeviceNet MAC ID and baud rate settings.
Normally, these switches are covered by a plastic hatch. Note that the node address can
not be changed during runtime, i.e. the D485 requires a reset for any changes to have
effect. Recycle the power supply to reset the module.
Figure 2-10: D485 configuration switches
State Status
Off Not powered / not online
Green Link OK, online, connected
Green flashing Online, not connected
Red Critical link failure
Red flashing Connection timeout
Off No power to device
Green Device operational
Green flashing Data size larger than configured
Red Unrecoverable fault
Red flashing Minor fault
- -
- -
Off Power off
Green, flashing Initializing and not running
Green Running
Red Stopped or subnet error, or timeout
Off Power off
Red/green Invalid or missing configuration
alternating
Green Initializing
Green flashing Running
Red flashing If the device status LED is flashing in a
sequence starting with one or more red
flashes, note the sequence pattern and
contact GE Multilin
8
7
6
5
4
3
2
1
D485 MODBUS TO DEVICENET CONVERTER – USER GUIDE