Table of Contents
Advertisement
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration
figure 45.4: Add zone, step 2
3 Click the OK button.
4 Select the output that must be added to the zone
from the left box. For example, MCI_02_AMP1.
5 Double click the selected output or click the >
button to add the output to the zone (see figure 45.5).
figure 45.5: Add zone, step 5
6 Repeat steps 4 and 5 to add additional outputs to the
zone.
7 Open the Volume settings category to do the volume
settings (see section 45.2.4).
8 Open the AVC settings category to do the AVC
settings (see chapter 49).
9 Submit the changes. Note that the changes are not
permanent until the configuration is saved (see
section 40.4.4 and section 40.4.5).
Bosch Security Systems | 2011-02
45.2.4 Volume settings
In the Volume settings category (see figure 45.6) of the
zone configuration page, it is possible to:
•
Set the maximum BGM volume (Maximum BGM
volume). It is not possible to adjust the BGM volume,
for example from a call station keypad, to a higher
level than the maximum BGM volume.
•
Set the initial, start-up BGM volume (Initial BGM
volume).
•
Schedule BGM volume attenuation (scheduled BGM
volume adjustment). These functions can be used to
automatically decrease the BGM volume during
certain periods of time (for example, in the evening).
During the periods of time that both functions are
active, the attenuations add up.
•
Schedule call volume attenuation (scheduled call
volume adjustment). With this function the call volume
can be automatically decreased during a certain
period of time (for example, in the evening).
figure 45.6: Volume settings
en | 375
Advertisement
Table of Contents
