Table of Contents
Advertisement
2011-02 | Installation and User Instructions | 5 | Call Stations
3
figure 17.3: Bottom view (without lid)
figure 17.4: Installation
Bosch Security Systems | 2011-02
1
4
17.5 Installation
The keypad is suitable for table-top use. In most cases it
will be connected directly to the call station, but it can
also be positioned between a number of other call
station keypads. Proceed as follows (see figure 17.4):
5
Caution
4
Disconnect the system cable from the (remote)
call station and back-up supplies before you are
going to connect a keypad to it. Connecting a
keypad to a powered (remote) call station can
damage the (remote) call station.
1 Remove the lid by sliding it to the left and snapping
it out of the keypad.
2 Connect the flat cable from the keypad connector to
the (remote) call station, or the previous keypad. The
short flat cable is for keypad to keypad
interconnection; the long flat cable (that is supplied
with the call station) is for call station to keypad
interconnection.
3 Slide the connecting plate into the bottom of the
keypad.
4 Fasten the connection plate using three screws.
5 Put the lid back by sliding it to the right and
snapping it into the keypad.
5
2
3
en | 213
Advertisement
Table of Contents
