Dialing Mode - Panasonic KX-TDA50 Pc Programming Manual

2.8 [1] Configuration
Default
Current status
Value Range
INS: The port is in service.
OUS: The port is out of service.
Maintenance Console Location
2.8.11 [1-1] Slot—Port Property - LCO Port
Programming Manual References
2.8.12 [1-1] Slot—Port Property - LCO Port—Connection Command
Feature Manual References
None

Dialing Mode

Selects the type of signal used to dial out to the analog CO line.
Default
DTMF
Value Range
DTMF, Pulse
Maintenance Console Location
2.8.11 [1-1] Slot—Port Property - LCO Port
Programming Manual References
None
Feature Manual References
1.4.2 Dial Mode Selection
CPC Signal Detection Time—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming CO
line calls before disconnecting the line. When None is selected here, the line will not be disconnected
when a CPC signal is not detected.
Default
400 ms
Value Range
None, 6.5 ms, 8 × n (n=1–112) ms
116 PC Programming Manual