Setting The Water Hardness; Extended Drying Fan Time; Service Mode 1; Test Program - Miele G 600 Series Technical Information

Technical Information

6.8.10.1.1 Setting the Water Hardness

1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Using the arrow buttons, enter the correct water hardness setting.
4. To save: Press the Start/Stop button twice.

6.8.10.1.2 Extended Drying Fan Time

1. Access Programming Mode.
2. Press the Top solo button once. The End light will light up.
3. Use Table 6-53 below to determine the drying fan time.
4. Press the Top solo button to toggle from 4.5 minutes to 14 minutes.
5. To save, press the Start/Stop button twice.
Program light
Pots & Pans

Table 6-53: G 694, G 894 Drying Time Settings

6.8.10.2

Service Mode 1

1. To access Service Mode 1, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and
hold the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop
light should now be blinking.
2. Press the Top solo and Delay Start buttons while turning the dishwasher on.
Successful accessing of Service Mode 1 is indicated by a lit Intake/Drain light
and a flashing Start/Stop light.
3. Using the arrow buttons, select a program and press the Start/Stop button.
4. Pressing the Start/Stop button repeatedly will allow the technician to advance
through the program. If the Start/Stop button is not pressed, the program steps
are carried out automatically, in their normal order.
Note: The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.
5. If the dishwasher door is opened and closed or the dishwasher is turned off and
on, the service mode will be canceled and the machine will continue to advance
normally.

6.8.10.2.1 Test Program

The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Using the arrow buttons, select the Rinse & Hold program and press the Start/Stop
button. The test program will start and advance automatically.
3. Pressing the Start/Stop button repeatedly will allow the technician to advance through
the program. If the Start/Stop button is not pressed, the program will run automatically.
6.8.10.3

Service Mode 2

Service Mode 2 is used to determine which upper electronic is in the appliance, to
change programmed functions and to access fault codes. Programmed functions
include increasing the water temperature, turning on or off the water softener, and
adding an interim rinse. Service Mode 2 is divided into 3 stages.
Options
4.5 minutes
14 minutes
116
G 600/G 800
Status of program light
Flashing
Lit