G 892, G 832; Programming Mode; Setting The Water Hardness; Table 6-45: G 892, G 832 Programming Flow Chart - Miele G 600 Series Technical Information

G 600/G 800
Example:
Sani Wash: 007
Normal 150: 127
Total operating hours: 7.127 hours
6.8.9

G 892, G 832

Enter Programming Mode
Enter Service Mode 1
Enter Service Mode 2

Table 6-45: G 892, G 832 Programming Flow Chart

6.8.9.1

Programming Mode

1. To access the programming mode, close the door and turn the dishwasher on.
The Start/Stop light must be blinking. If the Start/Stop light is not blinking, press
and hold the Start/Stop button for at least 3 seconds to exit the cycle. The
Start/Stop light should now be blinking.
2. Turn the dishwasher off.
3. Press and hold the Start/Stop button while turning the dishwasher on. Release
the Start/Stop button within 2 seconds. Successful accessing of the
programming mode is indicated by a blinking Salt light and a lit or flashing
Rinse light.
Note:
If the Rinse light is neither lit nor flashing, the machine has been programmed
to "without softener". See Service Mode 2 (Section 6.8.9.3) to turn the water
softener on or off.
6.8.9.1.1

Setting the Water Hardness

1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Using Table 6-46 below, press the down arrow button to choose the corresponding
program for setting the correct water hardness (e.g., "Normal Plus" = 8 to 11 gpg).
Programming Flow Chart
To access:
Water hardness settings
Heated drying (on/off)
To access:
Manual step mode
Component test program
To access:
Error messages
Program index number
Increased water temperature selection
Water softener (with/without)
Extended water intake
Extended drying fan time
Dishwasher width setting
EGS
111
Technical Information