Yamaha MT10M 2020 Owner's Manual page 71

rial enters the crankcase.
To check the engine oil level
1. After warming up the engine, wait
a few minutes for the oil level to
settle for an accurate reading.
2. With the vehicle on a level surface,
hold it upright for an accurate read-
ing.
3. Check the oil level through the
check window located at the bot-
tom of the left-side of the crank-
case.
TIP
The engine oil should be between the
minimum and maximum level marks.
Periodic maintenance and adjustment
1
1. Engine oil level check window
2. Maximum level mark
3. Minimum level mark
4. If the engine oil is at or below the
minimum level mark, remove the
oil filler cap and add oil
1. Engine oil filler cap
2. O-ring
8-11
5. Check the O-ring for damage, and
replace if necessary.
6. Install the engine oil filler cap.
To change the engine oil (and filter)
1. Start the engine, warm it up for
2
several minutes, and then turn it
off.
3
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap,
the engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
1
2
1. Engine oil filler cap
1
2
3
4
5
6
7
1
8
9
10
11
12