Cutler-Hammer OPTIMizer Programmer Manuals

Manuals and User Guides for Cutler-Hammer OPTIMizer Programmer. We have 1 Cutler-Hammer OPTIMizer Programmer manual available for free PDF download: Instructions For Operation Manual

Cutler-Hammer OPTIMizer Instructions For Operation Manual

Cutler-Hammer OPTIMizer Instructions For Operation Manual (32 pages)

Hand Held Programmer (For Use with Digitrip OPTIM Trip Units)

Brand: Cutler-Hammer | Category: Motherboard | Size: 3 MB

Table of Contents

Table of Contents
3
Section 1: Introduction

6
Hardware Description

8
- General
  8
- Package and External Connections
  8
  - 2-2.1 Internal Battery Power
    9
  - 2-2.2 External Connections
    10
- Operator Panel
  11
  - 2-3.1 Pushbuttons
    11
  - 2-3.2 General Pushbuttons
    11
  - 2-3.3 View Function Pushbuttons
    11
  - 2-3.4 Edit Values Pushbuttons
    12
  - Display
    13
- Figure Title
  
  14
- Programmable Categories
  14
- Optimizer/Accessory Specifications
  15
- Specification Summary
  15
Operation and Use

16
- General
  16
- Getting Started
  16
- Power Application
  16
- Optimizer Menu Diagram
  17
- Function Overview
  19
  - 3-4.1 Select Address
    19
  - 3-4.2 Find Baud/Address
    19
  - Find Product ID
    19
  - Change Baud/Addr
    19
  - 3-4.5 Rating Plug
    19
  - Metered Value
    20
  - 3-4.7 Test Mode
    20
  - 3-4.8 Setpoints Menu
    20
  - Password
    20
  - 3-4.10 Trip Event Count
    20
  - 11 Cause of Trip
    20
  - 3-4.12 Firmware Version/Revision
    21
- Security Password
  21
  - 3-5.1 Change Security Password
    22
- Assign Address/Select Baud Rate
  22
  - 3-6.1 Directly Connected Breaker Address and Baud Rate
    22
- Address/Baud Rate Change Accepted Display
  22
- Network Address Selection Display
  22
  - 3-6.2 INCOM Connected Address and Baud Rate
    23
- Cursor on Setpoints in Main Menu
  23
- Initial Setpoints Menu
  23
- Setpoints Menu with Long Delay Slope Active
  23
- Long Delay Slope Present Setting Displayed
  23
- Long Delay Slope with New Setting Displayed
  23
- Configure Trip Unit
  24
- Cursor on Metered Values in Main Menu
  24
- First Display in Metered Values
  24
- Cursor Indicating Phase B Current Active
  24
- PHASE B (IB) Current Selected and Displayed
  24
- Displayed Information
  25
- Cursor on Test Mode in Main Menu
  25
- First Display in Test Mode
  25
- Displayed Choices after Phase or Ground
  25
- Momentary Notice Displayed
  25
- Displayed Choice after Trip or no Trip
  25
- Test Trip Unit
  26
- Typical Cause of Trip Message
  26
- Copy and Download Commands
  27
Section 4: Troubleshooting and Maintenance

28
- Level of Repair
  28
- Troubleshooting Guide
  29
- Instructional References
  30
Appendix A Instructional References

30

Advertisement

Advertisement

Related Products

Cutler-Hammer Categories

Circuit breakers Controller Control Unit Test Equipment Protection Device

More Cutler-Hammer Manuals