Page 1
04201101 04501138 Outdoor Fireplace Copper Accent Copper Accent For Outdoor Use Only CAUTION WARNING Do not use this unit on a wood deck or on combustible THIS UNIT IS HEAVY! surfaces such as dry grass, leaves, mulch, etc. Do not use this unit near heat sensitive or combustible structures DO NOT assemble without a helper.
STOP! Missing a part? Call Our Help Line No need to go back to the store! The store where you made your purchase does not stock parts for this item. If you need parts, whether they are missing or damaged, call the Customer Service toll free Help Line.
Page 3
Attach the four corner post to the base using eight #10-24x1/2” screws (black) and eight #10- Latch corner post flange nuts (black) for each post. The hinge Corner Post with square hole corner post and latch corner post must be on the same side of the base.
Page 4
Attach the two Side Screens and One Back Screen to the Upper panels using twelve #10- 24x1/2 screws and twelve flange nuts Upper Panel Side/back Screen REPEAT FOR TWO REMAINING UPPER PANEL/SCREEN COMBINATIONS Place Side Screen Assemblies into bottom panel slot. Upper Side panels will be attached to corner post in a later step.
Page 5
Secure Side and Back screen assemblies using six #10-24x1/2” screws (black) and six #10-24 flange nuts (black). REPEAT FOR TWO REMAINING PANEL/SCREEN ASSEMBLIES Attach the Front Panel and Rear Screen Assembly using four #10-24x1/2” screws (black) and four #10-24 flange nuts (black).
Page 6
Align hinges on door assembly with hinge cutouts on corner post. Attach hinges to post using four #10-24x1/2” screws (black) and four #10-24 flange nuts (black). Inside of fireplace Door assembly Assemble door latch and door latch handle to door using one #10-24x1/2”...
Page 7
Place log rack into fireplace. Align log rack legs with holes in base. Log rack Place top cover onto fireplace. Insert four cover #10-24x1/2” hex-head screws (silver) from the outside and secure with four #10-24 flange nuts (silver) on inside.
Page 8
Assemble chimney panels as shown using eight #10-24x1/2” hex-head screws (silver) and eight #10-24 flange nuts (silver). NOTE: Chimney side panels have two mounting holes on the edge; front and rear panels do not. Chimney front or rear panel Holes on edges of Chimney Chimney...
Place hood cap screen into chimney, then place Hood cap hood cap onto screen. Hood cap screen HARDWARE LIST Hardware is shown actual size. You may have spare hardware after assembly is complete. #10-24x1/2” #10-24 #10-24x1/2” #10-24 screw (black) flange nut (black) hex-head screw (silver)
USE & MAINTENANCE It is recommended that coals and ashes are removed from your fireplace between each use. Coals and ash that build up can retrict air flow to the fire. MAKE SURE COALS AND ASH ARE COOL TO THE TOUCH BEFORE REMOVING. If your fireplace gets wet, be sure to dry it.
Page 11
Please register your grill online at: WWW.GRILLREGISTRATION.COM (If you register online, you do not need to send in this registration card.)