NOTE: Power interruptions will cause the clock to flash until reset. Stacking Models To remove lectern top from projector stand base, disconnect power cord and turn the black knob (located under the middle shelf) counter-clockwise until disengaged. Lift off lectern top and place in desired location.
Page 3
The external speaker outputs can be used to drive external speakers in lieu of the internal lectern speaker. When a plug is inserted into the external speaker jacks, the internal speaker is Auxiliary Microphone (XLR Jack) disconnected.
Page 5
Lectern Wiring Diagram – Sound System 3-Pin External Jack Speaker Speakers Clock Switch Tweeter Motherboard Preamp/Mixer Assembly Ribbon Mic 1 Cable Amplifier Assembly Dash Panel Circuit Housing Woofer Reading Lamp Switch Reading Power Lamp Supply Line In AC Pug Line Out 110 –...
Page 8
OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, (574) 267-8101, (800) 622-3737.
Need help?
Do you have a question about the Lectern and is the answer not in the manual?
Questions and answers