Husqvarna RZ3016 Operator's Manual page 16

4. Disengage the mower blades by lowering the blade
control lever out of the lock notch and into the down
position.
5. Move the steering controls outward to the locked (outer)
neutral position.
6. Move the throttle lever to the full throttle position.
NOTE: There is a detent at the full throttle position to aid in
setting the control.
OPERATION
If the temperature is below 32
up to the cold weather (snowflake) starting position.
When the engine has started, move the throttle lever back
to full throttle detent and allow the engine to warm up for a
short period before operating the unit. Failure to move the
throttle from the cold weather starting position will result in
poor engine performance, smoke and spark plug fouling.
7. Open the fuel valve.
8. Press in and turn the ignition key to the start position.
9. When the engine starts, immediately release the ignition
key back to the run position.
IMPORTANT INFORMATION Do not run the starter for
more than 5 seconds each time. If the engine does not
start, wait approximately 10 seconds before retrying.
10. Set the engine speed with the throttle. Allow the engine to
run at a moderate speed, approximately mid throttle, for
a short time before use. USE FULL THROTTLE WHEN
MOWING.
16
F, move the throttle lever
O