Insignia NS-DFLMR1 Quick Setup Manual

Quick Setup Guide | NS-DFLMR1

PACKAGE CONTENTS

• Macro ring flash
• 6 lens adapters (49mm, 52mm,
55mm, 58mm, 62mm, 67mm)
• Quick Setup Guide
FEATURES
• Compatible with all DSLR
cameras with a flash hot-shoe
• Can operate remotely with
PC sync cable (not included)
• 3.75" light ring with guide
number of 10m at ISO 100
• Ideal for close-up photos
• Five illumination power levels
• Xenon flash tube lighting
FEATURES
Macro Ring Flash
1
2
3
4
5
6
7
8
9
10 Locking ring
11 Lens adapters
# Item Description
Ring Flash and mounting slot Attaches to your camera lens.
Power switch Slide to turn on or off.
Charging indicator Brightly lit– The ring flash is ready to use.
Blinking every 1 second– Low battery.
Blinking every 3 seconds – In sleep mode.
Off - When the flash is turned off.
Flash level indicators Light to indicate the flash power level
(1/16, 1/8, 1/4, 1/2 , or 1/1).
Battery compartment Insert 4 AA alkaline or Ni MH batteries
(not included)
Flash level buttons Press + or – to select the flash power level.
Test button Press to test your flash.
PC sync socket Connect a PC Sync cable (not included) to
trigger the flash from another device or to
locate the flash control unit away from the
camera.
External power pack terminal For use with optional external battery pack
module (not included).
Secures the control unit to your camera.
Allows you to mount the ring flash on your
camera lens.

INSERTING THE BATTERIES

Note: Batteries are not included.
1 Slide the battery cover
down, then lift up to
open the battery
compartment.
2 Insert 4 AA alkaline or
NiMH Type batteries.
Make sure that the +
and – match what is
indicated in the
compartment.
3 Close the battery cover,
then slide it up until it
clicks into place.