Insignia NS-HTWSL6 Quick Setup Manual

Congratulations on your purchase of this high-quality
Insignia product. Your NS-HTWSL6 or NS-HTWPK6
represents the state of the art in portable fan heaters and is
designed for reliable and trouble-free performance.

IMPORTANT SAFETY INSTRUCTIONS

1 Read all instructions before using this heater.
2 This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m)
from the front of the heater and keep them away from the sides
and rear.
3 Extreme caution is necessary when any heater is used by or near
children and whenever the heater is left operating and unattended.
4 Always unplug heater when not in use.
5 Do not operate any heater with a damaged cord or plug or after
the heater malfunctions, has been dropped or damaged in any
manner. Discard heater, or return to authorized service facility for
examination and/or repair.
6 Do not use outdoors.
7 This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may fall
into a bathtub or other water container.
8 Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
9 To disconnect heater, turn controls to off, then remove plug from
outlet.
10 Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the heater.
11 To prevent a possible fire, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked.
12 A heater has hot and arcing parts inside. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
13 Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
14 Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or re-locatable power tap (outlet/power strip).
Before using your new product, please read these instructions to prevent any damage.
15 Avoid the use of an extension cord because the extension cord
may overheat and cause a risk of fire. However, if you have to use
an extension cord, the cord shall be No.16 AWG minimum size and
rated not less than 600 watts.

SAVE THESE INSTRUCTIONS

PACKAGE CONTENTS

• Portable wire heater
• Quick Start Guide
FEATURES
• Wire heating element
• Two power settings: 750 and 1200 Watt
• Silent operation
• Red LED power light
• Double over-heating protection
• Removable rear cover for easy cleaning
• Dust filter
Front
LED indicator
Frame
Grill
Front stand
Quick Setup Guide |
NS-HTWSL6/NS-HTWPK6
Portable Wire Heater - Gray, Pink
Back
Switch panel
Switch
Filter
cover
Back
stand
USING YOUR HEATER
1 Remove the heater from the package and place on a level
surface, such as a floor or desktop.
2 Plug the power cord into a standard 120V outlet. The red
LED turns on.
3 Slide the switch to LOW or HI.