Set-Up; Turning Speakers On; Pairing With Bluetooth Device; Taking Calls - Jackco Sound 2 ZT51000 User Manual

D. Set-up
Turning the Speakers On and Off:
1. Power on: press and hold (Power Button) of both speakers at the same time for 4 seconds,
Bluetooth Indicator will start blinking and accompanied by power on ring tone.
2. Power off: press and hold
(Power Button) of one speaker for 4
seconds, Bluetooth indicator will stop
blinking and accompanied with power off
ring tone.
5
2
Taking Calls with your connected to your phone:
When your phone receives an incoming call, a ring tone alert will come from your
To accept a call:
-Press the (Power Button) on the master speaker.
To end a call:
-Press the (Power Button) on the master speaker.
To reject a call or use call waiting feature, please revert to your phone controls.
7
G. Factory Reset Pairing Procedure:
1. 2.
Power On Pairing Speakers
4 sec.
Note: Please turn off the Bluetooth
connectivity on your device.
Press and hold for A.) Press again on B.) Allow 30~60 seconds
4 seconds to power on both speakers. Bluetooth for the speakers to pair
the speakers Indicator will be fast with each other. Once it is
blinking accompanied by a paired Bluetooth indicator
ringtone. will blink slowly and
accompanied by a ringtone.
9
2
speaker.
3. 4.
Pair with Device Complete Pairing Complete Pairing
30~60 sec.
< Bluetooth
Bluetooth
DEVICES
A B Sound² Not Paired
Now Discoverable
Press the button on one Turn on Bluetooth and
of the speakers to pair with search for "Sound²" and
your bluetooth device. click "Pair". Play music to
confirm that the pairing
process is complete. If
not, repeat the process.
Pairing with Bluetooth Equipped Device:
1. Pairing the 2 speakers: Press and hold
it will enter pairing mode for 10~30 seconds, and accompanied by the Bluetooth indicator
fast blinking. Once it is paired, Bluetooth indicator will blink slowly and accompanied by a ring
tone (Pairing time will vary depending on external interference)
2. Press the (Bluetooth Pairing) once, it will enter into paring mode with cell phone or
Bluetooth device. When the speakers have paired with your device successfully, you be
prompted with a ring tone. On one speaker Bluetooth indicator becomes solid on (Master: Left
Channel), while the other speaker will blink on-off once every 3 seconds (Slave: Right Channel).
2
Note: You may see two devices on your Apple iPhone, iPad, or iPod. You can pick either one of the devices to pair.
-Press and hold (Bluetooth Pairing) can cancel pairing with cell phone.
-If your device prompts you for a passcode, please enter 0000.
2
E. Connecting to via 3.5mm AUX input:
2
You can use speakers for music play with any device that has 3.5mm Audio out port.
Simply plug in the 3.5mm cable (included) into the speaker and into your device then play
music.
F. Recharging Battery:
Connect the provided USB cable to the charging port on the
speakers and a USB charging block. Battery Indicator glows red
when battery is charging, and indicator changes to green when
battery is full.
The charging time is approximately 3 hours from an empty battery
H. Troubleshooting
Problem
2
No audio from the speakers
Music playing through the speaker is
intermittent
A beep is heard during music play
(Power Button) of both speakers until power is on,
Solution
2
Check if the Bluetooth device and
speakers are powered on and paired. Increase
volume from your Bluetooth device.
Make sure the distance between the
2
Bluetooth device and the speaker is
within the 30 foot range, or check if there
are any device/equipment that generates
electromagnetic interference.
Battery is low, turn off speakers and recharge
the battery.
6
8
10