Health And Safety - Numatic CT 570 Owner's Instructions Manual

Dry Mode maintenance/fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner will not pick up any debris from the surface, switch off and remove the plug from the wall,
inspect the floor tool, wands and hose for blockages, if no blockages are found, the dust bag may be full if the
dust bag is not full the filter may be blocked.
Wet mode maintenance/fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from the wall,
has the float valve operated, this will shut off the suction and the pitch of the vacuum motor will change
Remove the power head and empty the liquid out of the container, if the container is empty, check that the floor
tool wands and hose are not blocked.
Spray extraction maintenance/fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before investigating were the
fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from the wall,
has the float valve operated, this will shut off the suction and the pitch of the vacuum motor will change, Re-
move the power head and empty the liquid out of the container, if the container is empty, check that the floor
tool wands and hose are not blocked.
If the spray nozzle is blocked a pin maybe used to clear the blockage.
No spray from nozzle and the pump tone changes, the solution tank is empty, refill the solution tank.
Flush the system with clean water after use.
After use always inspect the machine for damage.
INSTRUCTIONS FOR USE
TEST FOR COLOUR FASTNESS
Find an out of the way place which is not normally in view and test the
carpet / fabric for colour fastness by rubbing the cloth dampened with correctly
diluted NuChem 4.
Do not use on velvet type materials or any materials not suitable for wet cleaning
according to fabric manufacturers cleaning instructions.
For Normal soiling:
Pour one 40ml Measure into 5 litres of cold water.
For Heavy Soiling:
Pour two 40ml Measure into 5 litres of cold water.
NuChem 4 is non-foaming, bactericidal,
contains optical brightners and leaves
no tacky residues in the fabric and is
enhanced with both a delicate and
discreet verbena scent.

HEALTH AND SAFETY

Caution:
Keep out of the reach of children and pets.
Wear suitable gloves.
Aviod contact with skin and eyes.
In case of eye contact flush with clean water
seek medical attention.
In case of contact with the skin rinse with plenty of clean water.
NuChem 4 provided with this product.
244013 Page 12 of 16 04/13 (A03)
CONTENTS:
Composition:
Greater than 30% = among other ingredients
water
Less than 5% = SODIUM XYLENE SULPHONATE
CAC: 1300-72-7
Classified as Irritant
[xI] r36/37/38
Risk Phrases: R36 / 38: irritating to eyes and skin
Safety Phrases: S2: Keep out of the reach of
children
S24: Avoid contact with skin and eyes
S37: Wear suitable gloves
NUCHEM