Advertisement

v. 09.september.2015
owner's manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Nano Mark 300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mark Bass Nano Mark 300

  • Page 1 v. 09.september.2015 owner’s manual...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS PRÉCAUTIONS D’EMPLOI Read these instructions; Lire ces instructions; Keep these instructions; Conserver ces instructions; Heed all warnings; Suivre tous les conseils d’utilisations; Follow all instructions; Suivre toutes les instructions; Do not use this apparatus near water; Ne pas utiliser cet appareil au bord de l’eau; Clean only with dry cloth;...
  • Page 3: Front Panel

    FRONT PANEL 2 3 4 1) UNBALANCED ¼” INPUT JACK 2) SOLID STATE GAIN 3) CLIP LED 4) LOW EQUALIZATION CONTROL KNOB 5) MID LOW EQUALIZATION CONTROL KNOB 6) MID HIGH EQUALIZATION CONTROL KNOB 7) HIGH EQUALIZATION CONTROL KNOB 8) MASTER VOLUME LEVEL KNOB 9) POWER ON LED 10) MAIN ON/OFF SWITCH REAR PANEL...
  • Page 4: Technical Specs

    TECHNICAL SPECS POWER REQUIREMENT 100V; 120V; 230V; 240V 50/60Hz (Version factory preset inside the equipment) INPUTS Markbass apparatuses are manufactured to be sold and used in the country of purchase, and INPUT: impedance 2 Mohm, max. voltage 15 Vpp are factory preset to that country’s voltage. Due to homologation issues, the voltage may not EFFECT RETURN: impedance 33 Kohm, max.
  • Page 5: Limited Warranty

    LIMITED WARRANTY Markbass offers an international limited warranty on Markbass products purchased from any authorized Markbass dealer, effective from the day of purchase. The terms of this warranty vary from country to country; please contact the Markbass distributor in your country for details. Please register this product online at www.markbass.it to establish the date of purchase.
  • Page 6: Warranty Card

    WARRANTY CARD We’d like to thank you for choosing a Markbass product. If any problem occurs, please don’t hesitate to contact our support team at service@markbass.it. You can fill out this form and send a copy to Markbass (Parsek srl, Via Po 52, 66020 San Giovanni Teatino, CHIETI ITALY) or, even better, you can now register your warranty online in a matter of minutes, using our online registration form at www.markbass.it.
  • Page 7 NOTE...
  • Page 8 NOTE...
  • Page 9 NOTE...
  • Page 10 Product specifications are subject to change without notice Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52 - Tel. +39 085 446 3755 - Fax +39 085 440 7764 - www.markbass.it - info@markbass.it...

Table of Contents