Advertisement
getting started
Follow the eight simple steps below
1
install the gotype! software
Your handheld's sync software and cradle (or cable) are
required for the installation of this software. The GoType!
software must be installed and activated before the key-
board can be used.
NOTE: While the keyboard may be used as a cradle, we rec-
ommend that you first install the GoType! software via the
cradle that came with your Pocket PC device.
To install the GoType! Pro driver follow the steps below. For
more detailed information refer to the manual that came
with your connection software.
Installation instructions
1
Place your organizer in the cradle your received with
your Pocket PC and establish a connection with the
ActiveSync software.
2
Insert your GoType! disk.
3
Click the Start button, select Run, and type: a:setup.
4
Follow the on-screen prompts to complete the soft-
ware installation.
2
activate the gotype! software
The GoType! Pro driver software must be initially activated
before the keyboard can be used. IMPORTANT NOTE: The
GoType! Pro driver will only function correctly if the orga-
nizer is turned off BEFORE it has been docked with the key-
board.
To activate the GoType! driver
1
Tap the Start or Windows button on the organizer.
2
Tap GoType!, to launch the GoType! driver settings
application.
3
Tap the ON radio button.
4
The GoType! driver will now enable and disable
itself automatically. Note: the radio buttons will not
change state, but the driver will only activate if the
keyboard is dectected.
3
turn the organizer off
This is an extremely important step. The organizer must be
turned off BEFORE it is docked with the keyboard. Only
then will the GoType! Pro keyboard function correctly.
4
extend the keyboard stabilizer
A special foot at the rear of the keyboard may be extracted
to provide maximum stability when typing. It is recom-
mended that you extract this foot prior to using your key-
board.
5
set port switch to keyboard mode
To enable communication between the keyboard and the
organizer the GoType! port switch must be moved over to
the right hand side ( abc ). NOTE: You will not be able to
type on the keyboard while in serial mode (
6
dock the organizer in the keyboard
Place the organizer into GoType!'s integrated dock.
Remember, the organizer must be turned off during this
stage.
7
turn the organizer on
Press the Power button on the handheld to activate the
Pocket PC by pressing its power switch. If the GoType! dri-
ver has been correctly installed and activated (see step 2) it
will automatically enable keyboard input.
8
launch an application
You are now ready to type with your keyboard. Simply open
any program that accepts text input and start typing. It's
that easy.
Example: Creation of a text memo
Tap F5 to create a new memo and start typing. Text
should appear on the screen.
).
Advertisement
