Advertisement
U S E R ' S G U I D E
TROUBLESHOOTING
Problem
The vacuum cleaner does not start.
The suction power reduces and the noise increases.
Leakage of water during wet vacuuming.
SERVICE/ PROBLEM SOLVING
There are no user serviceable parts in this appliance. If the appliance is not operating correctly, please check that:
1. You have followed the instructions correctly.
2. The wall socket is switched on.
3. The mains power supply is ON.
If the appliance still does not work: In the first instance, consult your retailer for possible repair or replacement.
Possible Cause and Solution
The power supply is not properly connected.
Check the power cord, plug and socket.
The maximum level of water collection has been
reached. Turn the H2O unit off and disconnect the
power cord from the electrical outlet. Empty the
water.
There is a blockage. Check that the flexible hose,
extension tool, or accessory are not blocked and
remove any causes of blockage.
The HEPA filter requires replacement.
Float blocked and/or no float filter. Release the
float, clean and/or dry the foam filter.
7
U S E R ' S G U I D E
Assembly & Operating Instructions
N O T E : When assembling and preparing for use, make sure that the H2O unit is NOT plugged into the power sourc e .
1. Completely lower the handle that
locks the motor unit. (Figure 1)
2. Remove the motor unit. (Figure 2)
3. Lift out the removable water tank
using its handle. (Figure 3)
(Note: Water tank should easily
lift out. If it does not, please unwind
the power cord from the two holders
on the cradle car.)
4. To use the H2O unit for dry or wet vacuuming please pour in
water using the maximum/minimum markings on the side of the
water tank for reference. Do not fill below the minimum line or above the maximum line.
A minimum of 1.8 litres of water should be poured into the tank: do not exceed the maximum level of
3.3 litres marked on the tank.
Note: The suction tube can be removed making it easier to pour water into the tank. (Figure 4)
5. Replace the tank on the cradle car, position the motor unit in place and raise the
handle that locks the motor unit until it clicks into place.
6. Fit the flexible hose to the appliance, inserting the white end into the opening
and turning it clockwise. (Figure 5) To remove it, turn it counterclockwise.
7. Fit the extension tool onto the end of the flexible hose, pushing it fully into place.
8. Choose an attachment, and fit it snugly over the end of the telescoping extension tool.
NOTES
For hard floors, carpets and rugs use the standard head attachment (Part 17.)
and connect to the metal telescopic tube.
You can use one of the other accessories provided, such as the crevice tool or the
upholstery tool, by fitting it directly on to the siphon (Part 18.)
Plug the appliance into the power socket.
Turn the unit on by pressing the silver ON/OFF button on the top of the unit.
To switch the vacuum OFF simply press the same button once again.
The siphon on the flexible hose is fitted with a mechanical suction power to be varied
by simply moving the slide knob. (Fig.6)
Adjusting the telescope extension tube to suit your needs by pushing the locking knob.
(fig. 2)
(fig. 1)
(fig. 3)
(fig. 4)
(fig. 5)
(fig. 6)
4
Advertisement
