Troubleshooting - Oasis R1P Installation Instructions And Use And Care Manual

Chiller Use
Setting the Control
Your chiller has a dial for water temperature control.
For colder water: Turn it clockwise (to the right).
For less cold water: Turn it counterclockwise (to the left).
To shut down the chiller: Turn the dial to the Off position at full counterclockwise (extreme left).
Allow one hour to obtain chilled water.
Draining the Chiller
1. Unplug the chiller.
2. Shut off water supply to chiller.
3. Open faucet to release pressure.
4 . Disconnect the water lines attached to the chiller by
depressing collet on easy to connect fittings.
5. Tip chiller to the left side (power cord side) and drain water
into a large container.
6 . Set chiller in its normal upright position for storage.
Before calling for service...
If the chiller does not operate,
check for these conditions first:
 Has the circuit breaker tripped or has a house fuse blown?
 Is the power supply cord plugged into a grounded
3 prong outlet?
 Is the electrical outlet controlled by a switch?
6
Reconnecting the Chiller
1. Shut off water supply to chiller.
2. Put chiller in position, allowing a 2" (5 cm)
space around the side and top.
3 . Connect water lines as described in the ''Install the
Chiller'' section.
4 . Slowly open main water supply valve and open faucet
until water flows.
5. Plug in chiller and set dial to desired water temperature.
(See the "Setting the Control" section).
 Is the Temperature Control set to the "Off" position?
 Has the water supply been turned off?

Troubleshooting

PROBLEM CHECK THE FOLLOWING
Wa ter is not cold. Check that the circuit breaker has not tripped or the house fuse has not blown.

Check that power supply cord is plugged into electrical outlet.

Check if the electrical outlet is operated by a switch. The switch may have

turned the power off.
Check to see if chiller is attached to hot water line. If so, attach to cold water line.

Cold water in tank is still being chilled. Wait 15 minutes and check

temperature again.
Check that the Temperature Control is set to the "Max" setting.

Cold water drips or sputters from spout. Check that tubing is not bent or kinked.

Water does not flow from spout. Make sure main supply valve is open.

Check that water pressure to the chiller is 30 psi (138 kPa) minimum.

Unpleasant taste. If the dispenser has not been used for 3 or more days or if only 1 to 3 cups

of water are dispensed in a day, the tank may need to be purged. Open
the faucet for 2 to 3 minutes to purge the old water from the tank.
Allow new water in tank to reach desired temperature (approximately
1 hour) before dispensing water.
Chiller Wa r r a n t y
Warrantor: Oasis International 222 East Campus View Blvd. Columbus, OH 43235
ONE-YEAR LIMITED WARRANTY
The Warrantor promises the original purchaser to repair or replace, at the Warrantor's option, any part of this Proselect™ Chiller unit
that proves to be inoperative due to a defect in material or workmanship under normal use, for a period of one (1) year from the
date of purchase. This warranty will be honored provided the Proselect™ Chiller unit has been installed and operated in accordance
with the written instructions furnished with the Proselect™ Chiller unit.
GENERAL PROVISIONS AND EXCLUSIONS
This warranty applies only within Canada and the United States of America. This warranty will be honored if the unit is returned in
the original carton (or suitable replacement) along with proof of purchase. This warranty does not apply to bonus and/or accessory
items sold with the Proselect™ Chiller unit. This warranty does not apply if the affixed serial number is removed, defaced or obliterated.
This warranty does not cover poor performance, failure or damage of any part resulting from external causes such as alterations,
abuse, misuse, misapplication, corrosion, liming conditions or acts of God.
This warranty and the Underwriter's Laboratory or Canadian Standard Association listing for this Proselect™ Chiller unit are automatically voided
if this Proselect™ Chiller unit is altered, modified or combined with any other machine or device. Alteration or modification of this
Proselect™ Chiller unit may cause serious flooding, and/or hazardous electrical shock or fire.
Except as set forth herein or required by law, the Warrantor makes no other warranty, guarantee or agreement, express,
implied or statutory, including any IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
The Warrantor does not assume or authorize any person to assume any obligations of liability in connection with this product.
In no event will the Warrantor be liable for indirect, special or consequential damages (including, without limitation, economic
loss) or for any delay in the performance of this agreement due to causes beyond its control.
Some states or provinces do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to
you. Some states or provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state or from province to province.
If you need service, first see Troubleshooting Solutions. Additional help can be found by checking Assistance or Service" or by
c a l l i n g our customer service line at 1-800-950-3226, Monday through Friday, from 8:00 a.m. to 9:00 p.m. (EST), or by writing:
Proselect™ filtration system, Oasis International 222 East Campus View Blvd. Columbus, OH 43235
7