Advertisement
5
1)Attach conductivity sponge on bottom left gnd fpcb.
2) Attach insulation tape on bottom right tsp
connector
1
1) attached depending on base line for attachment
1) Assemble camera connector after attach
7
flash led to tweezers
2) Overturn board and assemble cif camera
connector of backside
1
2
1) Be careful to not to tear the FPCB.
2) Catch and disassemble fpcb's hard part when
disassembling tsp fpcb.
This Document can not be used without Samsung's authorization
SAMSUNG Proprietary-Contents may change without notice
6
1) Catch board with both hand and assemble
intenna left/right hook part to 1 to 2
Order
2) Attach motor using at intenna hole.
1
2
2
1) When assembling intenna, take care so that motor wire is
not damaged.
1) Place main board vertically on front
8
assay.
Be careful to not to tear the FPCB.
7-5
7. Level 2 Repair
1
Advertisement
