Table of Contents
Advertisement
Settings
Your Detector
Set Compass
After the detector is installed in your vehicle and Compass is turned On
using Menu mode, the system will automatically advance to the Set Compass
calibration screen from which the calibration can be performed.
WARNING
Before calibrating the Compass, go to a large parking lot
or other safe, low-traffic area.
When the instructions direct you to drive in two circles, make two complete
loops (in either direction) from any starting orientation at any convenient
speed. The loops need not be perfect and can be circles, small squares, four
three-point turns, or any pattern that makes at least two complete turns
within two minutes of starting the maneuver.
From the Calibrate Compass screen:
1. Press the City
2. Drive your vehicle in two circles.
3. Press the Mute
The system will store the calibration data and provide a completion message
on the display as well as a tone or voice message.
NOTE
If you do not press the Mute
Set Compass process, Compass calibration will automatically terminate. The
unit will provide a corresponding message.
Once the initial calibration is complete, you can go to Set Compass in the
User Settings Menu and recalibrate the Compass as needed by repeating
the three-step calibration process.
20 English
button to advance to the Compass screen.
button to complete the setting process.
button within two minutes after beginning the
Advertisement
Table of Contents
