Page 3
Total minimum openings for the whole build- Keep these instructions in a safe place ing are demonstrated by the following table: for future reference. Exhaust Opening Cooler Model CPL450 2.0m CPL600 2.5m CPL700 2.5m CPL850 3.0m CPL1000 4.0m...
THERMOST THERMOST THERMOSTA A A A A T FUNCTIONS T FUNCTIONS T FUNCTIONS THERMOST THERMOST T FUNCTIONS T FUNCTIONS 4 4 4 4 4 STARTING YOUR COOLER The ON/OFF button turns the cooler on and off. There are two modes of operation to choose from, Automatic mode or Manual mode.
THERMOST THERMOST THERMOST THERMOST THERMOSTA A A A A T FUNCTIONS T FUNCTIONS T FUNCTIONS T FUNCTIONS T FUNCTIONS 5 5 5 5 5 AUTOMATIC MODE AUTOMATIC MODE DISPLAY The AUTO button switches between Automatic mode and Manual mode. When “Auto” is dis- played the cooler is under Automatic control and will operate according to the temperature sensed at the thermostat.
THERMOST THERMOSTA A A A A T FUNCTIONS THERMOST T FUNCTIONS T FUNCTIONS 6 6 6 6 6 THERMOST THERMOST T FUNCTIONS T FUNCTIONS TIMED AUTOMATIC START You can set the cooler so that it will turn on after a set number of hours. 1.
THERMOST THERMOST THERMOSTA A A A A T FUNCTIONS T FUNCTIONS T FUNCTIONS T FUNCTIONS 7 7 7 7 7 THERMOST THERMOST T FUNCTIONS USING THE COOLER AIR NOT COLD ENOUGH Now that you have read these instructions, You may find that with the cooler running in press ON/OFF ON/OFF ON/OFF...
Page 8
ST ST ST STAND ANDARD BLEED SYSTEM AND DRAIN V ARD BLEED SYSTEM AND DRAIN V ARD BLEED SYSTEM AND DRAIN V ARD BLEED SYSTEM AND DRAIN V ARD BLEED SYSTEM AND DRAIN VAL AL AL AL ALVE 8 8 8 8 8 AUTOMATIC DRAIN VALVE This cooler comes with a standard bleed sys- tem or the optional automatic drain valve.
9 9 9 9 9 MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE Regular maintenance is essential to ensure the cooler operates efficiently for many years. Ser- vices must be performed before and after the summer season. More frequent servicing may be required in dusty conditions or in areas with poor water quality.
MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE PRE-SEASON SERVICE •Turn off the power supply to the cooler •Remove the pad frames as shown. •Ensure the power switch in the cooler is off. •Gently wash the pads to remove any dust build up during the winter period. If the pads are in poor condition, replace them.
TROUBLESHOO TROUBLESHOOTING GUIDE TROUBLESHOO TING GUIDE TING GUIDE TING GUIDE TROUBLESHOO TROUBLESHOO TING GUIDE PROBLEM - Unpleasant Odour CAUSE REMEDY Odour from new pads. Allow time to condition by running the cooler. PROBLEM - Inadequate Cooling CAUSE REMEDY Dry pads. Check water flow to pads.
Need help?
Do you have a question about the CPL450 and is the answer not in the manual?
Questions and answers