resi-linx RL-BV1000 Installation Manual

www.resi-linx.com
INSTALLATION MANUAL
A B C
1
2
SOURCE
3
4
1 3
1 3
2 4
2 4
A B

Cable Requirements

4 pair twisted cable
Hardware Connection
1. Ensure all power to equipment is switched off prior to
installation.
RL-BV1000
2. Connect RCA cable from Video terminals 1 A of
Transmitter to the Composite Video terminal of AV
Source.
3. Connect 3.5mm Audio cable from Audio terminals 1 B
of Transmitter to the Analogue Audio terminals of the AV
Source.
4. Repeat steps 2 - 3 for Source 2 - 4 inputs.
5. Connect RL-IR700/800* IR emitter to Common output F
of Transmitter. Place the other end within 25cm of the IR
receiver on the AV source (depending on environmental
conditions).
6. For Discrete IR control, connect RL-IR700/800 IR emitter
from Discrete output 1 or 2
head in front of IR Receiver of the desired device using
RL-ACC160* IR Emitter Shield. Choose which Discrete
IR source is to be controlled in each zone. Select via Dip
Switch D Discrete Emitter output port 1 or 2 and the
corresponding zone A, B etc.
7. Connect RJ45 socket C (output A) of Transmitter to
RJ45 input C of Receiver in Zone A.
WARRANTY
Vcomm Pty Ltd states that the warrant that the customer can rely on is that
provided by the manufacturer. In the event of any warranty claim please
contact us and we will forward it to the manufacturer. The manufacturer will
then determine the extent of their liability. This expressly negates, to the
extent possible by Australian law, any warranty reliance on Vcomm Pty Ltd.
®
Transmitter
H
OUTPUT
D E F G H
IR
A C E G
B F H
D
C
E and place emitter
AV Distribution Range
'linx-AV' 4 x 8 Composite Matrix Switch
RL-BV1000
E F
IR REPEATERS
1
COMMON
12V DC
IR SELECT
INPUT
2
1
2
A B C D E F G H
D G
RL-BV150B
8. Connect Video lead (yellow to yellow) from RCA Video
output I of Receiver to the yellow RCA Video input on
AV device (TV, etc).
9. Connect Audio lead L & R RCA connectors (red and
white) from output
RCA Audio inputs on the AV device.
10. Connect RL-BV500* IR target to input
Flat target can be easily mounted (either directly using
adhesive backing, or by using RL-ACC150* Target
Mount) to the desired location, anywhere within the line
of sight of remote controls.
11. Repeat steps 5 - 10 for connection of zones B - H.
12. Connect supplied 12V DC switch mode power pack to
power input G on Transmitter.
13. Once installation is complete, switch on power to all
equipment. Indicator LED's will illuminate to show which
Source 1 - 4 is selected in each of the Zones A - H.
RL-BV1000
A RCA Video output
B RCA Audio output
Receiver
C RJ45 socket
K C
D Discrete IR Select switch
E Discrete IR Emitter outputs
RL-BV150B
F Common IR Emitter outputs
G 12V DC Power input
H Indicator LED's
I RCA Video output
I
J
J RCA Audio output
K IR Target input
J on Receiver, to the corresponding
* Sold separately
Vcomm Pty Ltd
ABN: 99 091 281 524
K on Receiver.