Setting Up; Inserting The Needle / Threading The Thread - Pfaff 6500 Series Instruction Manual

9

Setting up

9

Inserting the needle / Threading the thread

.01
Fig. 9 - 01
● By turning the balance wheel, bring the needle bar to its t.d.c.
● Loosen screw 1.
● Insert the needle as far as possible.
● The long needle groove must be facing forwards.
● Tighten screw 1.
● Thread the sewing thread on the inside of the cover 2 as shown in the threading diagram.
● Adjust the relevant needle thread tension by turning milled nuts 3.
All instructions and regulations in this instruction manual must be observed.
Special attention must be given to all safety regulations!
All setting-up work must only be done by personnel with the necessary train-
ing. For all setting-up work the machine must be isolated from its power supply
by turning off the on/off switch or removing the machine plug from the electric
power socket!
1
Switch the machine off!
Danger due to unintentional starting of the machine!
Only use needles from the system intended for the machine, see Chapter 3
Specifi cations.
Setting up
3
2
27