Troubleshooting; General Troubleshooting - Qualcast SDS2810 Instruction Manual

Troubleshooting

General Troubleshooting

Problem
Motor will not start
Garden waste is not drawn in
Shredding material comes out
in chains
Possible cause
Collection box not fitted
correctly
Overload protection
No mains power supply
Cylinder running in reverse
Shredding material is too soft
Shredder blade remains
jammed
Pressure plate is incorrectly
adjusted
Customer Helpline 08456 400 800
Fault correction
Push the collection box
firmly to its correct position,
and place the safety switch
on the box to the ON
position.
To switch back on, start by
turning the operating mode
selection switch (A9) to the
"OFF" position.
Press the reset switch (A7).
Switch the device back on.
Check the socket, cable, lead
and plug for damage, and if
necessary, have any damage
repaired by qualified repair
personnel.
Change rotational direction
using the switch
Insert wood or shred dried
branches
Clear the jam (See section on
operation)
Readjust the pressure plate
(See section on adjusting the
pressure plate)
17