Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Camdata MeLock
- Page 1 User M anual ...
-
Page 2: Table Of Contents
6.1 LED indicator 7.1 Diagrams 8.1 Specifications 9.1 Resetting the device 10.1 Troubleshooting 11.1 Warranty 12.1 Camdata information Camdata © -‐ V ersion 1 .0 May 1 1, 2 011 ... -
Page 3: Introduction
When the operator has been sitting at the PC for more than about 30seconds the MeLock and activator 'Pair' with each other. If the operator moves away from the PC, the pair is broken and the MeLock will send the Windows Lock key codes (windows key + L key) to the PC, which causes the Windows log in screen to be displayed. -
Page 4: Installation
If the operator moves away from the PC, the pair is broken and the MeLock will send the Windows Lock key codes (windows key + L key) to the PC, which causes the Windows log in screen to be displayed. -
Page 5: Calibration
5.1 Calibration The MeLock contains a feature to allow it to be re-calibrated to suit the situation in which it is used. The default factory calibration should be suitable for most circumstances, however if you feel that you have to move too far from the PC before it locks (or not far enough) the calibration procedure is described below. -
Page 6: Diagrams
The Sentinel unit will Beep when an activator is within range. Sensitivity adjustment by potentiometer on side of the unit. Camdata © -‐ V ersion 1 .0 May 1 1, 2 011 ... -
Page 7: Troubleshooting
9.1 Reset to factory and Calibration Reset to factory calibration with double tap on the Melock when it is not paired with an activator. But I am in the process of changing this – The calibration feature will be removed. -
Page 8: Warranty
PO Box 738 Harston Cambridge CB22 7WY Camdata © -‐ V ersion 1 .0 May 1 1, 2 011 ...
Need help?
Do you have a question about the MeLock and is the answer not in the manual?
Questions and answers