Table of Contents
Advertisement
Chapter 2
System Setup
Panel Mounting
The mounting panel thickness should be less than 6 mm (0.236 in.).
Note
TPC-2106/2106T User Manual
Follow these steps to mount the TPC-2106/2106T in a panel:
1.
Be sure the adhesive waterproof gasket on the front bezel is in position.
2.
Install the TPC-2106/2106T into the panel opening. (Refer to
Appendix A, Specifications, for cutout dimensions.)
3.
Hook the clamps included in the accessory pack to the holes around the
four sides of the bezel.
4.
Insert the screws included in the accessory pack into the clamps. To
fasten the TPC-2106/2106T to the panel, tighten the screws so they
push against the mounting panel.
2-4
ni.com
Advertisement
Table of Contents
