Advertisement
Quick Links
Advertisement
Summary of Contents for Smarter tools MAX-20
- Page 1 USER´S MANUAL BATTERY CHARGERS MAX -20...
- Page 2 Please read this User’s Manual thoroughly before using the charger. Ⅰ. PRODUCTS OVERVIEW Like all other products from SMARTER TOOLS , this item was developed on the basis of state-of-the-art, engineering and using the most reliable and modern electrical/electronic components, it is tiny, high-efficiency as well as energy-saving;...
-
Page 3: Ⅱ. Technical Parameters
Ⅱ. TECHNICAL PARAMETERS... -
Page 4: Safety Regulations
Ⅲ .INDICATIONS AND SYMBOLS EN60335-2-29: Standards for charger ：Single-phase transformer-rectifier ： Symbol of battery Read the User’s Manual carefully before using. ： ： Indoor use only IP20： Protection class MIN： DC Min output current MAX： DC Max output current FUSE T5A : Input fuse 12V/24V Switch Ⅳ. - Page 5 For the protection class is IP20, the product shall not be used outside the room, where it is the rainy and snowy. The grounding wire must be connected to the socket so that the pin for grounding inside the plug can be reliably earthed. ...
- Page 6 Ⅴ . OPERATION INSTRUCTIONS To ensure that the charger and battery are used correctly and the machine is kept from damage, the following rules must be followed: 1．Instructions for the battery ● When battery does not have sufficient electricity, the terminal voltage of it can be normal, which means the 12V battery has the terminal voltage of 12V and the 24V battery has the terminal voltage of 24V.
- Page 7 battery is loaded or charged. When loaded, the voltage is lower than normal value of terminal voltage, whereas it is higher than normal value when the battery is being charged. If the battery is topped for some time (about 10-30 minutes) after it is loaded, and the terminal voltage is still lower than normal value, the battery may have quality defects.
- Page 8 5.The charging was done when the ammeter decreased close to “0” . 6. After the charging is finished, the power should be turned off first, and then the battery clamp should be removed from the battery. Note : ● In the course of charging, the temperature of electrolytic solution in the battery should not be more than 45 ℃.
-
Page 9: List Of Parts
transformer is cooled to resume the charging process. Ⅸ LIST OF PARTS Specification Item GB/T 818-2000 M4×16 Cross rexxessed pan head tapping screw GB/T848-2002 4 cushion Plastic front panel fixed connetion 50A 85C17-A ammeter K10-2 output fuse KCD-25 power switch 250w/10A 5x20 Input fuse WS/01-MAX-30-04...
Need help?
Do you have a question about the MAX-20 and is the answer not in the manual?
Questions and answers