Contents Important safety information......3 Bluetooth mode ..........12 Instructions for use ...........5 Bluetooth (BT) mode ....... 12 Check the package contents ....5 Connecting or ‘Pairing’ with your Tower speaker ..........12 Where to put your Tower speaker ..5 Listening to Music/Audio using Setting up ............
Important safety information Your Tower speaker should be treated with care. The information below has been provided in the interest of safety and will help you to enjoy this product and the benefits it brings for many years. • Keep the product and all its parts out of reach of small children. •...
Page 4
• Only use recommended batteries or those of the same equivalent type. • Do not mix old and new batteries or batteries of different types. • Batteries are to be inserted with the correct polarity. • The supply terminals are not to be short-circuited. •...
Instructions for use Check the package contents The package contains: • 1 x Tower speaker • 1 x Base • 2 x Assembly screws • 1 x Dock support stand • 1 x Stereo audio connection cable with 3.5mm plug •...
Setting up Attach the Tower speaker to the separate base using the screws supplied. 2. Insert the dock support stand supplied into the slot on the top of the Tower speaker, just behind the dock connector. 3. Insert 2 x AAA batteries into the remote control, noting the ‘+’ and ‘-’ markings and position the batteries the correct way around.
Using your Tower Speaker with Dock Switch on Press and release the ‘ ’ button on the top of the Tower speaker or on the remote control. The display will fully switch on and the current mode (iPod/BT/LINE/AUX/ Radio frequency) will be displayed. Switch off Press and release the ‘...
Your Tower Speaker with Dock Top view Source Wire FM aerial iPod/iPhone/iPad (iPod/BT/LINE/Aux/FM Radio (Top rear) Dock support stand Standby LED iPod/iPhone/iPad Lightning dock connector Aux in Volume+ Power on/off Volume- Tune - (FM Radio) Tune + (FM Radio) Play/Pause Previous track/fast search Next track/fast search Repeat (iPod mode)
Your Tower Speaker with Dock Remote control effective range: Notes: The remote signal may not be received if there is an obstacle between the remote and the Tower speaker. Direct sunlight or other bright light sources shining on the remote sensor may affect the performance of the remote control.
iPod/iPhone/iPad mode iPod/iPhone/iPad mode Check that your Tower speaker is in iPod mode. If you are not already in iPod mode, briefly press and release the ‘Source’ button on the top of your Tower speaker or on the remote control, until you are in iPod mode (check the display). Note: Your Tower speaker has an Apple lightning connector.
Menu: Press the menu button to display your iPod/iPhone menu. Check your product display. Press the menu button repeatedly to enter or exit the display menus. (Up/Down) Use the up and down buttons to move up and down or highlight the displayed options.
Note: Some products will automatically search for a new device and so the ‘Add new device’ option is not available. 4. When found, your Tower speaker will be displayed as ‘BUSH Audio’. Select the device name to begin pairing. 5. When pairing is complete the ‘BT’ in the Tower speaker display will stop flashing and a tone will sound.
Using the FM radio Wire FM aerial Please make sure that the wire FM aerial on the back of the Tower speaker is fully extended before you attempt to tune to an FM station. This will ensure that the maximum signal strength is available when the Tower speaker begins to scan. Extending the aerial also ensures the best possible sound quality.
Tune to an FM station preset In FM mode: Briefly press the ‘Channel -’ or ‘Channel +’ button on the remote control to move through the preset locations (01-20). 2. When you stop on a preset location your Tower speaker will tune to that station and begin to play.
LINE in mode LINE in mode If you are not already in LINE in mode, briefly press and release the ‘Source’ button on the top of the Tower speaker or on the remote control until you are in LINE in mode. ‘LINE’...
AUX in mode Aux in mode If you are not already in Aux in mode, briefly press and release the ‘Source’ button on the top of the Tower speaker or on the remote control until you are in Aux in mode. ‘AUX’...
Troubleshooting If you are experiencing problems with your Tower speaker, there are some quick and easy checks that you can do, which may help to solve the problem. Problem Solution No sound / power: • Check that the mains power cable is connected securely, is plugged in and the power switched •...
Page 18
Problem Solution Your iPod/iPhone/iPad • If you use a cover with your iPod/iPhone/iPad, does not dock: please remove it before docking your product. • Remove your iPod/iPhone/iPad and check that the connector on the dock and your iPod/iPhone/iPad are clean and free from obstructions.
Page 19
Problem Solution Unable to pair with a • Check that you are in Bluetooth mode. Press Bluetooth device: and release the ‘Source’ button on the top of the Tower speaker or on the remote control until you are in Bluetooth (BT) mode. Check the display.
General information This symbol indicates that this product should not be treated as normal household waste and it should be recycled. Please take it to your nearest collection facility or for further details contact your local council or visit www.recycle-more.co.uk Batteries contain substances that may be harmful to the environment and human health.
PRODUCT GUARANTEE This product is guaranteed against manufacturing defects for a period of Year This product is guaranteed for twelve months from the date of original purchase. Any defect that arises due to faulty materials or workmanship will either be replaced, refunded or repaired free of charge where possible during this period by the dealer from whom you purchased the unit.
Need help?
Do you have a question about the 238 and is the answer not in the manual?
Questions and answers