Greenfire GCI60 Owner's Manual

Cast iron pellet insert

Advertisement

Quick Links

Hampton GCI60
PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS
PELLET-BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
Contact your building or fire officials about restrictions and installation inspection
Improper installation, adjustment, alteration,
s e r v i c e
o r
m a i n t e n a n c e
injury, property damage, or loss of life.
Refer to this manual. For assistance or
additional information consult an authorized
installer or service agency.
Tested by:
GCI60-079
FPI FIREPLACE PRODUCTS INTERNATIONAL, LTD. 6988 Venture St., Delta, BC, Canada V4G 1H4
requirements in your area.
WARNING:
c a n
IMPORTANT: SAVE THESE INSTRUCTIONS
Greenfire® GCI60
OWNER'S MANUAL
Cast Iron
Pellet Insert
Do not store or use gasoline or other flammable
c a u s e
vapours and liquids in the vicinity of this or any other
appliance.
Installation and service must be performed by an
authorized installer or service agency.
FOR YOUR SAFETY:
9.16.15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GCI60 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Greenfire GCI60

  • Page 1 Greenfire® GCI60 OWNER'S MANUAL Cast Iron Pellet Insert Hampton GCI60 PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET-BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH. Contact your building or fire officials about restrictions and installation inspection requirements in your area.
  • Page 2 The authority having jurisdiction should be consulted before installation to determine the need to obtain a permit. Rates: This manual describes the installation and operation of the Regency GCI60 pellet heater. This heater meets the 2015 U.S. Environmental Protection Agency’s wood emission limits for wood emission limits sold after May 15, 2015.
  • Page 3: Table Of Contents

    Control Board Functions.............7 Automatic Safety Features of Your Pellet Stove......7 Operating Your Pellet Stove............8 Turning Your Pellet Stove Off............9 Slider/Damper Set-Up..............9 Routine Cleaning and Maintenance............10 Optional Service Rail Kit............13 Warranty...................14 Installation Data Sheet...............17 Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 4: Introduction

    FLAMMABLE LIQUIDS: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in the heater. Keep all such liquids well away from the heater while it is in use. Hampton GCI60 Cast Pellet Insert Owner's Manual...
  • Page 5: Safety Warnings & Recommendations

    If the ashes are disposed of by burial in soil or otherwise locally dispensed, they should be retained in the closed container until all cinders have thoroughly cooled. Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 6 OF YOUR STOVE, REGENCY FIREPLACE PRODUCTS LTD. GRANTS NO WARRANTY IMPLIED OR STATED FOR THE INSTALLATION OR MAINTENANCE OF YOUR STOVE. THEREFORE, REGENCY FIREPLACE PRODUCTS LTD. ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S). SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. Hampton GCI60 Cast Pellet Insert Owner's Manual...
  • Page 7: Dimensions & Specifications

    Testing Standard Weight (with full hopper) Consumption on High ASTM 1509-04 500 lb (227 Kg) 6.5 lb/hr (2.95 Kg/hr)* *Note: Consumption will vary with the type and quality of pellets / fuel used. Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 8: Operating Instructions

    C. VACUUM SWITCH: Notifies when the unit has lost vacuum. This can be caused by either a combustion fan/vent failure, or simply the unit’s ash pan door, pedestal door. It will display a #2 flash code. Starting a Fire in Your Pellet Stove Hampton GCI60 Cast Pellet Insert Owner's Manual...
  • Page 9: Operating Your Pellet Stove

    LOW setting for 30 minutes. If the thermostat contacts Figure 5: Thermostat Switch close within the 30 minutes, the HEAT LEVEL will return to the previous MANUAL in AUTO/OFF position. COMBUSTION HEAT FAN TRIM Hampton GCI60 Cast Pellet Insert Owner’s Manual LEVEL...
  • Page 10: Turning Your Pellet Stove Off

    (hard ash build-up). If all of these steps are followed, there should be no visible emissions. Hampton GCI60 Cast Pellet Insert Owner's Manual...
  • Page 11: Routine Cleaning And Maintenance

    10. Set the fire grate in place, it should sit level on the front and back of the burn pot liner. Lock it in with the lever on the burn Burn Pot pot. 11. Close the door Figure 8: GCI60 Burn Pot Assembly. Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 12 Open the bottom of the “T” to dump the ash, then vacuum as much of the ash out of the vent pipe as possible. FRESH AIR INTAKE (Biannually) Inspect periodically to be sure that it is not clogged with any foreign materials. Cleaning Your Pellet Stove Hampton GCI60 Cast Pellet Insert Owner's Manual...
  • Page 13 Insert the glass into the retainer and screw the door to the retainer. The use of substitute materials is prohibited. Use Hampton Part#: GCI60-024. Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 14: Optional Service Rail Kit

    Fig. 12. 6. Adjust leg height and lock them in using the thumb screws. (Fig 12) 7. Slide unit forward on rails. Figure 11: GCI60 with Service Rail Kit Quick Release Pin Thumb Screw Figure 12: Close up of Front Rail...
  • Page 15: Warranty

    #, type of unit, problem, and part or parts requested. A copy of the bill of sale/ proof of purchase must also accompany any submitted claims, without this information the warranty will be invalid. To the Distributor: Sign and verify that work and information are correct. Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 16: Exclusions And Limitations

    17. Damage to plated surfaces caused by fi ngerprints, scratches, melted items, or other external scores and residues left on the plated surfaces from th use of abrasive cleaners or polishes is not covered in this warranty. 18. The Limited Warranty does not cover tarnish, discoloration or wear on the plated surfaces. Hampton GCI60 Cast Pellet Insert Owner's Manual...
  • Page 17: Installation Data Sheet

    Retain all receipts for both service and/or parts which may have been replaced. Lack of service/ maintenance is the largest contributor to malfunction of an appliance and is not covered under the terms of this warranty. Hampton GCI60 Cast Pellet Insert Owner’s Manual...
  • Page 18 Phone #: ___________________________________________________________ Date Installed: ______________________________________________________ Serial No.: __________________________________________________________ Hampton GCI60 Regency, Hampton and Greenfire are registered and / or proprietary trademarks of FPI Fireplace Products International Ltd. © Copyright 2015, FPI Fireplace Products International Ltd. All rights reserved. Printed in Canada...

Table of Contents