Summary of Contents for Ideal Boilers Ideal airtherm 4.5
Page 1
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers. For the very latest copy of literature for specification purposes please visit our website...
Ideal airtherm 4.5, 9 & 12 Air Source Heat Pump INTRODUCTION OPERATING THE HEAT PUMP Your air source heat pump is designed to heat your home and When setting the programmer, allow extra time for the heat to provide domestic hot water (DHW). Your installer will have...
WINTERISING/START UP LOSS OF SYSTEM WATER PRESSURE If the heat pump is being left for a short period of time AND has The system pressure gauge indicates the central heating adequate frost protection, i.e. frost protection stat and/or system pressure and that if the normal COLD pressure of the antifreeze, the heat pump can be left in the same way as you system is seen to decrease over a period of time then a water would leave a conventional central heating boiler.
TROUBLE SHOOTING The control panel for the air source heat pump is located under a secure cover on the right hand side of the machine. Access should only be required in the event of a problem as the installer will set the water flow temperature appropriate to the heating - see diagrams.
Page 6
Ideal Consumer Helpline products. The right is therefore reserved to vary specification without notice. Tel: 01621 878549 Ideal Boilers, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN. Tel. www.idealboilers.com 01482 492251 Fax. 01482 448858. Registration No. London 322 137.