Table of Contents
Advertisement
2.2 Camera Shroud removal / installation.
Figure 10. Illustrates the camera shroud in position over the camera module
Figure 11. Illustrates the location of the tab for the camera shroud in close position (twist On/Off)
Fig. 10
The dome is equipped with a quick release camera liner supported by 3 tabs attached to a ring affixed
on the PTZ mechanism. The liner needs to be removed in order to reach the dip switch settings of the
dome for proper addressing and selection of the communication protocol / baud rate.
Step 1
: Restrict the movement of the dome
mechanism and rotate the camera liner
counterclockwise from "close" to "open"
position as illustrated.
Step 2
: Remove the camera liner to
gain access to the dip switch
settings located on the
PC-Board underneath the
camera.
Note: Illustrations are for reference purposes only and may vary from actual package contents depending selected
installation options at time of order.
9
Fig. 11
Advertisement
Table of Contents
