Attaching Feet To Your Ms308; Final Setup - Mordaunt Short Premiere MS308 Owner's Manual

Getting Started
Attaching feet to your subwoofer
Your MS308 subwoofer comes with feet and spikes
which must be fitted to space the down-firing speaker unit
the correct distance from the floor for optimum operation
The spikes attach to the bottom of the feet (as shown
below left).
There are eight pilot holes on the bottom of the speakers.
The feet are located and secured here with the wood
screws supplied (below right). Level as required.
8
Final System Setup
Once all wiring connections are complete and you have
positioned your Premiere loudspeakers, turn on your
amplification system and run the relevant Level Calibration
Sequence to establish the correct individual volume level
for each speaker channel.
Finally, play some test material and make final adjustments
to the Active Sub Frequency Cut-Off point that allows the
best overall integration within the system, sounding neither
too boomy, or overly thin. After this step, It may be
necessary to run the Level calibration again to make final
level checks.
Running In
Your new loudspeaker system will require approximately
10 hours of normal use to allow the components to settle
into their working routine and reach their optimum
performance.