First Time Use - Swann SR11040 Installation And User Manual

Installation Notes
4. Ensure the supply voltage of socket is same as rating label.
5. The plug must be properly inserted to the wall socket.
6. The mains supply socked must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord
7. The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn't rock.
DO NOT SITE THE PRODUCT WHERE THE AMBIENT TEMPERATURE IS LIKELY TO
DROP BELOW 5 DEGREES CENTIGRADE - EG: GARAGE OR SHED

First Time Use

1. It is important that upon receipt you stand your appliance upright for at least 4 hours
before switching on to allow the system to settle. Remove all packaging & any transit tapes
2. Clean the inside of the cabinet with a soft, dry cloth prior to switching on
3. When using the product for the first time, set the thermostat inside the product to 1
without any food inside. When it starts, you will hear the quiet hum of the compressor. You
may also hear the circulation of liquids and gases in the refrigeration system. This is normal
on first start up, Generally it will take 3 hours for the appliance to reach temperature. Once
temperature has been reached then put the food inside.
4. The temperature of the freezer can be adjusted by rotating the disc of the thermostat. The
higher the value on the setting of the thermostat, the colder it will be
5. Do not put too much food in the freezer. Avoid opening the doors too frequently as this will
waste energy and can cause excessive frost build-up.
6
SR11040_IM.indd 6 30/01/2014 11:00