Installing And Removing The Battery And Card; Insert The Battery - Canon EOS 1200D Basic Instruction Manual

Installing and Removing the Battery and Card

Load a fully charged Battery Pack LP-E10 into the camera. The camera
can use an SD, SDHC, or SDXC memory card (sold separately). The
captured images are recorded onto the card.
Make sure the card's write-protect switch is set upward to
enable writing/erasing.
Installing the Battery and Card
Write-protect switch
24
Open the cover.
1
Slide the lever as shown by the
arrows and open the cover.

Insert the battery.

2
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
Insert the card.
3
As shown by the illustration, face the
card's label side toward the back of
the camera and insert it until it clicks
in place.
Close the cover.
4
Press the cover until it snaps shut.
When you set the power switch to
<1>, the number of possible shots
(p.28) will be displayed on the LCD
monitor.