Table of Contents
Advertisement
Wiring
1. Use 12 gauge wire for distances up to 30 feet (9 meters) and 10 gauge wire for longer
runs.
2. Use a 10A fuse and fuse holder or circuit breaker connected to the positive terminal.
See drawing #3 below.
NOTE: The power switch on the joystick panel should be in the off position before
supplying power to the spotlight.
Joystick Control Panel Installation
1. The joystick control panel should be installed on a flat surface. The panel is watertight
and moisture resistant, but should be installed in a protected location to allow proper
operation.
2. Use the foam gasket to mark the mounting holes and rectangular hole (3-1/2" x 2-3/8")
for the panel and cut out the hole. See drawing #4 on page 6.
3. Pull the RJ11 phone line cable from the spotlight through the mounting hole and
connect it to the panel.
4. Remove the frame/cover from the panel, remove the clear protective coating, and fit
panel into the rectangular hole. Secure the control panel with two #8 self-tapping
5
Drawing #3
Advertisement
Table of Contents
