Summary of Contents for Duramaxx 90000
- Page 1 32 lbs / 38 lbs TROLLING MOTOR MODEL: 90000 / 90001 OPERATOR'S MANUAL TOLL-FREE HELPLINE: 1 866 523-5218 IMPORTANT: READ THIS MANUAL CAREFULLY BEFORE OPERATNG YOUR NEW DURAMAXX TROLLING MOTOR. RETAIN FOR FUTURE REFERENCE.
-
Page 2: Table Of Contents
BATTERY..........................PROPELLER........................MAINTENANCE........................TROUBLESHOOTING......................WARRANTY.......................... PRODUCT SPECIFICATIONS 90000 (32 lbs) / 90001 (38 lbs) Motor..........................12V Thrust.......................32 lbs / 38 lbs Prop speeds....................1300 - 1800 RPM Forward speed......................5 speeds Reverse speed......................3 speeds NOTE: To be used with Deep Cycle 12V marine battery. (Sold Separately) -
Page 3: Functions
FUNCTIONS Tiller speed control: Controls Speed, forward, reverse and steering direction. Prop shaft tilt release lever Shaft depth adjustment collar Clamping knobs Boat mounting bracket Adjustable shaft Propeller 12V DC Motor... -
Page 4: Adjustments
ADJUSTMENTS MOUNT THE MOTOR: Install the motor on the transom of the boat. Be sure to tighten the clamp screws securely. Tighten Loose DEPTH ADJUSTMENT: 1. Firmly grasp the shaft and hold it steady 2. Loosen the steering tension knob and depth collar knob until the shaft slides freely. 3. - Page 5 ADJUSTMENTS Tiller speed control Prop shaft tilt release lever Shaft depth adjustment collar Clamping knobs WARNING: WHEN MAKING ANY ADJUSTMENTS TO MOTOR OR PROPELLER THE BATTERY MUST BE DISCONNECTED FROM THE TROLLING MOTOR WIRE LEADS.
-
Page 6: Operation
OPERATION TWIST TILLER: • These motors offer a choice of five forward and three reverse speeds. • The speed control may be operated in either direction, forward or reverse. Turn the tilt twist tiller handle counterclockwise from O (off) to increase reverse speed and clockwise from O (off) to increase forward speed. Thrust decreases as you approach O from either direction. -
Page 7: Battery
BATTERY 12V BATTERY INFORMATION: NOTE: BATTERY SOLD SEPERATELY Trolling motors will operate with any deep cycle marine 12V battery. For best results it is recommended to use a deep cycle marine battery with a minimum of 105 ampere hour rating. (As a general on the water estimate, your 12V motor will draw one ampere per hour for each pound of thrust produced when the motor is running on high. -
Page 8: Propeller
PROPELLER WEEDLESS PROPELLER SLOT END PROP NUT WASHER Fig.A DRIVE PIN WARNING: DISCONNECT THE MOTOR FROM THE BATTERY BEFORE BEGINNING ANY PROP WORK OR MAINTENANCE. PROPELLER REPLACEMENT: 1. Using a cloth or glove, hold the propeller and loosen the prop nut with a (1/2") socket. 2. -
Page 9: Maintenance
MAINTENANCE 1. The propeller must be cleaned of weeds and fishing line. Line can get behind the prop, wear away the seals and allow water to enter the motor. Disconnect battery and check this after each use. 2. To prevent accidental damage during trailering or storage, disconnect the battery whenever the motor is out of the water. -
Page 10: Troubleshooting
TROUBLESHOOTING 1. MOTOR DOES NOT RUN OR LACKS POWER: - Check battery terminal connections - Check battery voltage or battery health/amperes to ensure of correct working levels (this may need to be done by a technician with a correct voltage meter) 2. -
Page 11: Warranty
LIMITED WARRANTY 2 —Year Limited Warranty THIS WARRANTY IS NOT TRANSFERABLE AND DOES NOT COVER: Products sold damaged or incomplete, sold “as is”, sold reconditioned or used as rental equipment. Delivery, installation or normal adjustments explained in the owner’s manual. Damage or liability caused by shipping, improper handling, improper installation, incorrect voltage or improper wiring, improper maintenance, improper modification, or the use of accessories and /or attachments not specifically recommended.