Lumagen CAT6 FTP Manual

Advertisement

HDMI-CAT6 Cable Extender
Manual
Lumagen® Inc
.
Legal Notices:
TO THE EXTENT NOT PROHIBITED BY LAW, IN NO
EVENT SHALL LUMAGEN, ITS SUPPLIERS, OR ITS
DEALERS, BE HELD LIABLE FOR INJURY TO PERSONS
OR PROPERTY, ANY LOST REVENUE, LOST PROFIT,
SPECIAL, INCIDENTAL, INDIRECT, CONSEQUENCIAL, OR
PUNITIVE DAMAGES, IMPAIRMENT OF OR DAMAGE TO
OTHER GOODS, HOWEVER CAUSED REGARDLESS OF
THE THEORY OF LIABILITY, RESULTING FROM THE
USE OF, OR INABILITY TO USE, THIS PRODUCT, EVEN IF
LUMAGEN, ITS SUPPLIERS, OR ITS DEALERS, HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
LUMAGEN SHALL NOT BE LIABLE FOR OMISSIONS OR
ERRORS IN ITS DOCUMENTATION OR SOFTWARE.
LUMAGEN RESERVES THE RIGHT TO MAKE CHANGES
TO ITS PRODUCTS AND DOCUMENTATION WITHOUT
NOTICE.
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC rules, Canadian ICES-
003, and CISPR 22. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that
which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
Lumagen is a registered trademark of Lumagen, Inc. Vision HDP, Vision
HDQ, RadianceXD, RadianceXE, RadianceXS, HDMI-HDMI, HDMI-CAT6
and other Lumagen product names, are trademarks of Lumagen, Inc. Other
trademarks are the property of their respective owners. Unauthorized
modifications to this equipment may void Lumagen's limited warranty and
the user's authority to operate this equipment.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CAT6 FTP and is the answer not in the manual?

Questions and answers

Summary of Contents for Lumagen CAT6 FTP

  • Page 1 Consult the dealer or an experienced radio/TV technician for help. Lumagen is a registered trademark of Lumagen, Inc. Vision HDP, Vision HDQ, RadianceXD, RadianceXE, RadianceXS, HDMI-HDMI, HDMI-CAT6 and other Lumagen product names, are trademarks of Lumagen, Inc. Other trademarks are the property of their respective owners.
  • Page 2: Installation Instructions

    When long cables, or cable extenders, have issues in a given system, Introduction: Lumagen has found that it is often due to problems with the DDC The Lumagen HDMI 1.4 CAT-cable extender is designed to allow signals. Since the DDC signals are needed for HDCP and EDID...
  • Page 3 There are two light-emitting-diode (LED) indicator lights on the current will damage equipment. Lumagen recommends connecting transmitter and on the receiver. These show the connection status as cables in the following order:...
  • Page 4 Setup Tips and Trouble Shooting: - When installing new CAT cable, always install CAT6 FTP cables (i.e. shielded), or better, for use with HDMI-CAT extenders. - Avoid bundling the high-frequency video cables with LAN and other digital cables. Using CAT6 FTP cables reduces the potential for crosstalk between cables.

This manual is also suitable for:

Cat6 stp

Table of Contents