Installation; Operation - Vision SP-2000P Owner's Manual

INSTALLATION

1. FIT BRACKETS TO SOUNDBAR Measure width of flat-panel mounting holes and fit the
brackets to the soundbar at same width.
2. PUT FLAT-PANEL ON TABLE SURFACE FACE-DOWN
3. LAY SP-2000P ASSEMBLY ON TOP OF FLAT-PANEL Position the slots in the brackets over
the flat-panel mounting holes.
4. FIX WALL OR FLOOR STAND BRACKET TO REAR OF FLAT-PANEL. The SP-2000P brackets
will be sandwiched between the flat-panel and the mount.
5. FIT FLAT-PANEL ASSEMBLY TO STAND OR WALL MOUNT. Then route power and input
cables to loudspeaker.

OPERATION

1. TURN ON AND OFF Long press on volume dial
2. CHANGE INPUT Short press on volume dial
NOTE: When power is turned on the last volume setting and input will resume.
5
SP-2000P_manual_en