Summary of Contents for Lutema MITPS04CS
- Page 1 Manual MODEL: • MITPS04CS • MITPS04CN • MITPS04CG • MITPS04CB • MITPS04CO The ULTIMATE Rechargeable Portable Digital Audio System...
-
Page 2: Speci Cations
“The ULTIMATE Rechargeable Portable Digital Audio System” Maintaining your WaveCube Aqua: - Avoid contact with liquids - Avoid prolonged exposures to extreme temperatures or humid weather - Make sure that the battery is fully charged before use. For a more detailed manual visit www.lutema.com... -
Page 3: Control Buttons
Appearance / Control Panel: Battery should be fully charged before use. Charging the Unit: - Connect the USB cord to computer and speaker. - Battery indicator,top right hand screen, ashes while charging. - MicroSD Card or the USB key runs through battery life faster. - Do not use a more than 5.4 V \ charging device to avoid damaging the speaker components. -
Page 4: Troubleshooting
Troubleshooting: - The device does not turn on: check the charge level of battery. If it is low or null, connect the unit to a power supply. Let it charge and try again. - Poor signal FM radio: a) Move away from other electronics to avoid interference. b) Remove any connected headphones. - Page 5 Powering/charging: - To recharge the battery: Connect the USB cord into the computer and into the speaker. - You’ll see the battery indicator on the top right hand corner ashing, indicating the battery is charging. - ON/OFF switch is found on the left side. - You can expect one to three hours of use depending on how you are using the speaker and the volume level.
-
Page 6: Playing Music
Led Lighting: The WaveCube Aqua has a LED controller that will pulse to the music. Press and hold MENU for 3 seconds to LED lighting on/o . Playing Music: - Have the WaveCube speaker fully charged. - Turn on the speaker. - Default setting will always be the CLOCK. -
Page 7: Setting Clock
- Remove any headphones connected to the device. - Make sure the internal antenna has been pulled up all the way. - Plug in the Lutema RadioWave Antenna external antenna into the Line-in jack. SETTING CLOCK: The default setting will always be the CLOCK.
Need help?
Do you have a question about the MITPS04CS and is the answer not in the manual?
Questions and answers