Fellowes Powershred DS-1 Manual page 2

http://www.monomachines.com
Safe Sense™ touch guard area/sensor (orange)
Shredder head
Paper entry
Mesh basket
Reverse polarity switch
Step
SET UP — To Test Safe Sense™ Touch Guard Sensor Follow Instructions Below
Shredder comes fully assembled. Remove basket packing material and plug in.
Press Auto-On ( ) Touch test area Sensor lights up
CAPABILITIES
Will shred: Paper, small paper clips, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies,
newspaper, cardboard, large paper clips, laminates or plastic other than
noted above
Paper shred size:
Confetti-Cut ..............................................5/32" x 1-3/8" (3.9 x 35mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Always unplug when
not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc.– away from shredder openings. If object enters top
opening, press and hold Reverse (R) to back out object.
• Avoid touching exposed blades under Confetti-Cut shredder head.
2
http://www.monomachines.com
Overheated (red)
Standby (green)
Control switch
Auto-On ( )
Off
Reverse (R)
Magnetic
safety interlock
Lift and
remove basket
Slide switch
If sensor does Plug in, replace basket
not light
Unplug and Repeat touch test
remove basket
Maximum:
Sheets per pass (Confetti-Cut) ............................................................. 11*
Cards per pass ........................................................................................1
Passes per day ................................................................................10-20
Paper width .............................................................................9"/229mm
Continuous operation ..............................................................4-5 minutes
*20 lb., 8.5"x11" paper at 120v, 60 Hz, 4.5Amps; heavier paper, humidity or
other than rated voltage may reduce capacity.
• Never use aerosol, petroleum-based or other flammable
products on or near shredder. Do not use canned air on
shredder.
• Do not use if damaged or defective. Do not open shredder
head. Do not place near or over heat or water source.
• The socket-outlet shall be installed near the equipment and shall be
easily accessible.
ENGLISH
OPERATION
Model DS-1
Continuous operation:
5-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5-minutes will trigger
20-minute cool down period.
Safe Sense™ touch guard sensor will stop shredder when touched by adult or child.
TROUBLESHOOTING
Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the
below procedures.
Sensor lights up
Press and hold Alternate slowly back and forth
Reverse (R)
MAINTENANCE
Follow oiling procedure below and repeat twice.
Run regularly in reverse for
one minute
Lubricate when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Set to Off
shredder stops running
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE
machine to be free from defects in material and workmanship for 5 years from APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be
the date of purchase by the original consumer. Fellowes warrants all other parts liable for any consequential or incidental damages attributable to this product.
of the machine to be free of defects in material and workmanship for 1 year from This warranty gives you specific legal rights. The duration, terms, and conditions of
the date of purchase by the original consumer. If any part is found to be defective this warranty are valid worldwide, except where different limitations, restrictions,
during the warranty period, your sole and exclusive remedy will be repair or or conditions may be required by local law.
replacement, at Fellowes' option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized your dealer.
repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR
For More Info
Click Here --->
PAPER
Press Auto-On ( )
Set to Off
CARD
Hold credit card
Press Auto-On ( )
at edge
Set to Off Pull uncut paper from
paper entry
*Apply oil Press Auto-On ( )
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
For more details or to obtain service under this warranty, please contact us or
Feed into paper entry
and release
Set to Off
Feed into center of entry
and release
Shredder doesn't start:
Make sure shredder is
plugged in
Make sure control switch is in
Auto-On ( ) position
Clear paper particles covering
magnetic safety interlock
Press and hold
Reverse (R)
Wait 20 minutes for red light
to turn off
Shred one sheet Press and hold
Reverse (R)
2-3 seconds
3